enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Trailer connectors in North America - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   If you have a trailer with a lot of lights the diode and relay wiring is preferred, but if you have a trailer with a simple light arrangement it is usually sufficient to wire to 58L. In market there are many special converters [ 1 ] [ 2 ] [ 3 ] that solves the problem of connecting a car with European wiring to a trailer with North American wiring.

3. ISO standards for trailer connectors - Wikipedia

   en.wikipedia.org/wiki/ISO_standards_for_trailer...

   7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.

4. Trailer (vehicle) - Wikipedia

   en.wikipedia.org/wiki/Trailer_(vehicle)

   A utility trailer is a general purpose trailer designed to by towed by a light vehicle and to carry light, compact loads of up to a few metric tonnes. It typically has short metal sides (either rigid or folding) to constrain the load, and may have cage sides, and a rear folding gate or ramps.

5. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   A non-grounded device may be two-pole, two-wire; three-pole, three-wire; etc. [citation needed] The numerals following the hyphen is the current rating of the device in amperes. This number is followed by the letter 'R' to indicate a receptacle (socket) or 'P' to indicate a plug (prongs). As an example, the 5-15R is the common 125 V two-pole ...

6. Trailer connectors in military organizations - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   The lighting inside the vehicle shall also be extinguished if it is not specifically shaded. Pin C is for Convoy Lamps, which is the special convoy lighting, corresponding to the tail lights, to be used while driving in the dark. Pin H is for rear fog light and the rear fog light shall also be disabled when pin A is active.

7. Trailer connectors in Australia - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   In this pinout for an ISO 1724 connector, the position light pin is used for electric brakes (Pin 5, 58R), which means that if you connect a trailer with electric brakes to a towing vehicle wired according to ISO 1724 and turn on the position lights the trailer will be braking. Pin 2 (54G) is in the Australian wiring standard the reversing ...