Ad
related to: can throttle body cause misfire in car roof coating
Search results
Results from the WOW.Com Content Network
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
This means a roof coating actually becomes the top layer of a composite roof membrane and underlying system. As such, the roof coating is the topmost layer of protection for the membrane, receiving the impact of sunlight (both infrared and ultraviolet (UV)), rain, hail and physical damage. Roof Coatings should not be confused with deck coatings.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
If the exhaust system is hot enough to autoignite, an after-fire may result; this can be seen as a flame discharging through the exhaust system. On a fuel-injected engine, ignoring the throttle (no fuel) while starting permits electronic logic systems to produce the correct fuel mixture, often based on exhaust gases.
However, tests of the Camry by Car and Driver in 2009, attempting to use the brakes to stop acceleration of a purposely stuck throttle at 70, 100 and 120 miles per hour (110, 160 and 190 km/h), found that the test driver was able to reduce speed to 10 mph (16 km/h) in all instances, and in the 70 and 100 mph (110 and 160 km/h) tests, stop the ...
It could also cause issues for the occupants of the car as it could be drawn into the inside of the car, which was often unpleasant. Around 1961 a new design was created. This design routed the crank breather into the intake of the car. This meant that the vapors and oil mist could be burnt and expelled out of the car through the exhaust.
It is usually installed right behind the throttle valve in the throttle body. Single-point injection was a relatively low-cost way for automakers to reduce exhaust emissions to comply with tightening regulations while providing better "driveability" (easy starting, smooth running, freedom from hesitation) than could be obtained with a carburetor.
Stuck throttle (unrelated to pedal position) [12] [13] Shorting of tin whiskers [14] [15] Diesel engine runaway: Diesel engine power is governed by the amount of fuel supplied. Excessive pressure in the crankcase can force mist of engine oil into the intake manifold, which can be burned in the same fashion as Diesel fuel, thus causing runaway.
Ad
related to: can throttle body cause misfire in car roof coating