Search results
Results from the WOW.Com Content Network
A shock tube detonator is a non-electric explosive fuze or initiator in the form of small-diameter hollow plastic tubing used to transport an initiating signal to an explosive by means of a shock wave (also known as a percussive wave) traveling the length of the tube. [1] Shock tube is used to convey a detonation signal to a detonator. Shock ...
Heat transfer takes place by convection here, and the tubes are finned to increase heat transfer. The first three tube rows in the bottom of the convection section and at the top of the radiant section is an area of bare tubes (without fins) and are known as the shield section ("shock tubes"), so named because they are still exposed to plenty ...
The shock that eventually forms increases the temperature and pressure of the test gas and induces a flow in the direction of the shock wave. Observations can be made in the flow behind the incident front or take advantage of the longer testing times and vastly enhanced pressures and temperatures behind the reflected wave.
Laser peening (LP), or laser shock peening (LSP), is a surface engineering process used to impart beneficial residual stresses in materials. The deep, high-magnitude compressive residual stresses induced by laser peening increase the resistance of materials to surface-related failures, such as fatigue, fretting fatigue, and stress corrosion cracking.
The typical efficiency of TEGs is around 5–8%, although it can be higher. Older devices used bimetallic junctions and were bulky. More recent devices use highly doped semiconductors made from bismuth telluride (Bi 2 Te 3), lead telluride (PbTe), [10] calcium manganese oxide (Ca 2 Mn 3 O 8), [11] [12] or combinations thereof, [13] depending on application temperature.
Pros and cons of a balance transfer. Erik J. Martin. March 19, 2024 at 5:00 AM. Key takeaways. A balance transfer credit card can help you pay off your debt faster and save money on interest, but ...
The project included experiments, including high temperature and engine tests collectively called the Heat Transfer Reactor Experiments: HTRE-1, HTRE-2 and HTRE-3 at the National Reactor Test Station (now Idaho National Laboratory) as well as an experimental high-temperature molten-salt reactor at Oak Ridge National Laboratory – the ARE.
A plant in control theory is the combination of process and actuator. A plant is often referred to with a transfer function (commonly in the s-domain ) which indicates the relation between an input signal and the output signal of a system without feedback, commonly determined by physical properties of the system.