enow.com Web Search

  1. Ads

    related to: recommended amplifier power for speakers 2 way antenna tower
  2. crutchfield.com has been visited by 100K+ users in the past month

    • Home Amplifiers

      Deliver Clean Power to Your Home

      Speakers in One or More Rooms

    • 4-Channel Amps

      Power Front and Rear Speakers or

      a Single Set of Speakers and a Sub

Search results

  1. Results from the WOW.Com Content Network
  2. Tower Mounted Amplifier - Wikipedia

    en.wikipedia.org/wiki/Tower_Mounted_Amplifier

    A Tower Mounted Amplifier (TMA), or Mast Head Amplifier (MHA), is a low-noise amplifier (LNA) mounted as close as practical to the antenna in mobile masts or base transceiver stations. A TMA reduces the base transceiver station noise figure (NF) and therefore improves its overall sensitivity ; in other words the mobile mast is able to receive ...

  3. Bi-amping and tri-amping - Wikipedia

    en.wikipedia.org/wiki/Bi-amping_and_tri-amping

    A single amplifier can usually power a woofer and a tweeter only through a post-amplifier crossover filter, which protects each driver from signals outside its frequency range. Bi-amping of speakers requires double the channels of amplification and can be accomplished using two ordinary amplifiers in either a vertical or horizontal arrangement.

  4. Audio power - Wikipedia

    en.wikipedia.org/wiki/Audio_power

    For most audio applications more power is needed at low frequencies. This requires a high-power amplifier for low frequencies (e.g., 200 watts for 20–200 Hz band), lower power amplifier for the midrange (e.g., 50 watts for 200 to 1000 Hz), and even less the high end (e.g. 5 watts for 1000–20000 Hz).

  5. Antenna amplifier - Wikipedia

    en.wikipedia.org/wiki/Antenna_amplifier

    In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...

  6. Signal strength in telecommunications - Wikipedia

    en.wikipedia.org/wiki/Signal_strength_in...

    The electric field strength at a specific point can be determined from the power delivered to the transmitting antenna, its geometry and radiation resistance. Consider the case of a center-fed half-wave dipole antenna in free space, where the total length L is equal to one half wavelength (λ/2). If constructed from thin conductors, the current ...

  7. Radio repeater - Wikipedia

    en.wikipedia.org/wiki/Radio_repeater

    A radio repeater is a combination of a radio receiver and a radio transmitter that receives a signal and retransmits it, so that two-way radio signals can cover longer distances. A repeater sited at a high elevation can allow two mobile stations, otherwise out of line-of-sight propagation range of each other, to communicate. [1]

  8. Transmitter power output - Wikipedia

    en.wikipedia.org/wiki/Transmitter_power_output

    In radio transmission, transmitter power output (TPO) is the actual amount of power (in watts) of radio frequency (RF) energy that a transmitter produces at its output. [1] TPO is a concept related to effective radiated power (ERP), but refers to the power output of a transmitter, without accounting for antenna gain. The ERP for VHF/UHF ...

  9. Output power of an analog TV transmitter - Wikipedia

    en.wikipedia.org/wiki/Output_power_of_an_analog...

    The output power of a TV transmitter is the electric power applied to antenna system. There are two definitions: nominal (or peak) and thermal. Analogue television systems put about 70% to 90% of the transmitters power into the sync pulses. The remainder of the transmitter's power goes into transmitting the video's higher frequencies and the FM ...

  1. Ads

    related to: recommended amplifier power for speakers 2 way antenna tower