Search results
Results from the WOW.Com Content Network
A compound crown molding built up out of several individual trim elements Decorative pilaster of natural cherry hardwood topped with crown molding Crown molding may be a complex build-up of multiple trim elements, in this case built-out slightly above a window with short 90-degree returns The relief on this short 90-degree return of crown molding was back-cut with a coping saw
Credit cards. Credit cards can work fine for smaller improvements, but watch out for high interest rates. Consider using a 0% intro APR credit card to pay for expenses so you can make the most of ...
Ovolo: Simple, convex quarter-round moulding that can also be enriched with the egg-and-dart or other pattern; Neck moulding; Panel mould: A moulding that is flat on the back and profiled on the face. It is applied directly on a flat surface like a wall or flush door in squares or rectangles to simulate a panel.
This moulding can be terminated at the side by ornamentation called a label stop. The hood mould was introduced into architecture in the Romanesque period, though they became much more common in the Gothic period. Later, with the increase in rectangular windows they became more prevalent in domestic architecture.
In that case, the window likely has a shelf-like piece of interior trim work—often made of wood, tile, or stone—which is distinct from the exterior window sill. The technical term used by carpenters , window manufacturers, and other professionals for this piece of trim work is window stool , but it is also referred to as a window sill.
A building's surface detailing, inside and outside, often includes decorative moulding, and these often contain ogee-shaped profiles—consisting (from low to high) of a concave arc flowing into a convex arc, with vertical ends; if the lower curve is convex and higher one concave, this is known as a Roman ogee, although frequently the terms are used interchangeably and for a variety of other ...
Consider the fabrication of a hollow plastic box, without lid. Once the plastic has hardened around the mold, the mold must be removed. As the plastic hardens, it may contract slightly. By tapering the sides of the mold by an appropriate "draft angle", for instance 2° (two degrees), the mold will be easier to remove.
The tapers are generally cut at an angle between 1:8 to 1:10. The ends of a plain scarf are feathered to a fine point which aids in the obscuring of the joint in the finished work, while in other forms of scarf the ends are frequently cut to a blunt "nib" which engages a matching shoulder in the mating piece.