enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Constant-voltage speaker system - Wikipedia

   en.wikipedia.org/wiki/Constant-voltage_speaker...

   The voltage is constant only in the sense that at full power, the voltage in the system does not depend on the number of speakers driven (as long the amplifier's maximum power is not exceeded). [2] Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or ...

3. Bi-amping and tri-amping - Wikipedia

   en.wikipedia.org/wiki/Bi-amping_and_tri-amping

   A speaker system has to be wired to accommodate either configuration, typically with two sets of binding posts, one set for the bass and one set for the mid-highs. A single amplifier can usually power a woofer and a tweeter only through a post-amplifier crossover filter, which protects each driver from signals outside its frequency range.

4. Sound reinforcement system - Wikipedia

   en.wikipedia.org/wiki/Sound_reinforcement_system

   Three audio power amplifiers Rear panel of a power amplifier with 2 × 700 Watt (4 Ohm) - very similar to the topmost device in the image above - showing typical connectors for professional use: From left, symmetrical XLR-sockets for signal input, alternatively audio jack sockets, loudspeaker terminals of type Speakon (center), alternatively ...

5. Audio power - Wikipedia

   en.wikipedia.org/wiki/Audio_power

   Audio power is the electrical power transferred from an audio amplifier to a loudspeaker, measured in watts.The electrical power delivered to the loudspeaker, together with its efficiency, determines the sound power generated (with the rest of the electrical power being converted to heat).

6. Damping factor - Wikipedia

   en.wikipedia.org/wiki/Damping_factor

   A high damping factor in an amplifier is sometimes considered to result in the amplifier having greater control over the movement of the speaker cone, [3] particularly in the bass region near the resonant frequency of the driver's mechanical resonance. Speaker diaphragms have mass, and their compliant suspension components have stiffness.

7. Nominal watt - Wikipedia

   en.wikipedia.org/wiki/Nominal_watt

   The actual electric power may vary from about twice the nominal power down to less than one tenth. Loudspeaker efficiency is measured with respect to nominal power in order to emulate the situation outlined above where a low internal impedance amplifier is used with a loudspeaker. The convention is to supply one nominal watt during testing.

8. Powered speakers - Wikipedia

   en.wikipedia.org/wiki/Powered_speakers

   An active full-range loudspeaker. Powered speakers, also known as self-powered speakers and active speakers, are loudspeakers that have built-in amplifiers.Powered speakers are used in a range of settings, including in sound reinforcement systems (used at live music concerts), both for the main speakers facing the audience and the monitor speakers facing the performers; by DJs performing at ...

9. Bi-wiring - Wikipedia

   en.wikipedia.org/wiki/Bi-wiring

   Amplifier and loudspeaker with two elements and crossover networks. Top: normal connection. Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two ...