Search results
Results from the WOW.Com Content Network
A variant of the metric perm is used in DIN Standard 53122, where permeance is also expressed in grams per square meter per day, but at a fixed, "standard" vapor-pressure difference of 17.918 mmHg. This unit is thus 17.918 times smaller than a metric perm, corresponding to about 0.084683 of a U.S. perm.
Volume is not the important factor – depth is. The average water pressure acting against a dam depends on the average depth of the water and not on the volume of water held back. For example, a wide but shallow lake with a depth of 3 m (10 ft) exerts only half the average pressure that a small 6 m (20 ft) deep pond does.
References will be made to "actual" flow rate through a meter and "standard" or "base" flow rate through a meter with units such as acm/h (actual cubic meters per hour), sm 3 /sec (standard cubic meters per second), kscm/h (thousand standard cubic meters per hour), LFM (linear feet per minute), or MMSCFD (million standard cubic feet per day).
Some SI units of volume to scale and approximate corresponding mass of water. To ease calculations, a unit of volume is equal to the volume occupied by a unit cube (with a side length of one). Because the volume occupies three dimensions, if the metre (m) is chosen as a unit of length, the corresponding unit of volume is the cubic metre (m 3).
Some SI units of volume to scale and approximate corresponding mass of water. A litre is a cubic decimetre, which is the volume of a cube 10 centimetres × 10 centimetres × 10 centimetres (1 L ≡ 1 dm 3 ≡ 1000 cm 3). Hence 1 L ≡ 0.001 m 3 ≡ 1000 cm 3; and 1 m 3 (i.e. a cubic metre, which is the SI unit for volume) is exactly 1000 L.
The volume of such a mixture is slightly less than the sum of the volumes of the components. Thus, by the above definition, the term "40% alcohol by volume" refers to a mixture of 40 volume units of ethanol with enough water to make a final volume of 100 units, rather than a mixture of 40 units of ethanol with 60 units of water.
A related measure is "mega standard cubic metres per day" (MSm 3 /d), which is equal to 10 6 Sm 3 /d used in many countries outside the United States. [1] One MMSCFD equals 1177.6 Sm 3 /h. When converting to mass flowrate, the density of the gas should be used at Standard temperature and pressure.
This pressure distribution is simply the pressure at all points around an airfoil. Typically, graphs of these distributions are drawn so that negative numbers are higher on the graph, as the C p {\displaystyle C_{p}} for the upper surface of the airfoil will usually be farther below zero and will hence be the top line on the graph.