Search results
Results from the WOW.Com Content Network
The network host IP interface binds the gateway address to the MAC address of the physical gateway by broadcasting IP datagrams and caching the MAC address of the reply from the gateway in an ARP table stored on the host. The gateway address may be added manually. On Windows computers, the gateway address is configured using the TCP/IP Properties.
When a device leaves the network, the GTK also needs to be updated. This is to prevent the device from receiving any more multicast or broadcast messages from the AP. To handle the updating, 802.11i defines a Group Key Handshake that consists of a two-way handshake: The AP sends the new GTK to each STA in the network.
The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.
MAC addresses are primarily assigned by device manufacturers, and are therefore often referred to as the burned-in address, or as an Ethernet hardware address, hardware address, or physical address. Each address can be stored in the interface hardware, such as its read-only memory , or by a firmware mechanism.
In IEEE 802.11 wireless local area networking standards (including Wi‑Fi), a service set is a group of wireless network devices which share a service set identifier (SSID)—typically the natural language label that users see as a network name. (For example, all of the devices that together form and use a Wi‑Fi network called "Foo" are a ...
This address is used by only one physical router at a time, and it will reply with this MAC address when an ARP request is sent for the virtual router's IP address. Physical routers within the virtual router must communicate within themselves using packets with multicast IP address 224.0.0.18 and IP protocol number 112 [ 1 ] for IPv4, or ff02 ...
Key management and the establishment of secure associations is outside the scope of 802.1AE, but is specified by 802.1X-2010. The 802.1AE standard specifies the implementation of a MAC Security Entities (SecY) that can be thought of as part of the stations attached to the same LAN, providing secure MAC service to the client. The standard defines
It has a wired connection to the ISP, at least one jack port for the LAN (usually four jacks), and an antenna for wireless users. The wireless gateway could support wireless 802.11b and 802.11g with speed up to 56 Mbit/s, 802.11n with speed up to 300Mps and recently the 802.11ac with speed up to 1200 Mbit/s. [3]