Search results
Results from the WOW.Com Content Network
40G Transceiver Form Factors The QSFP+ form factor is specified for use with the 40 Gigabit Ethernet. Copper direct attached cable (DAC) or optical modules are supported, see Figure 85–20 in the 802.3 spec. QSFP+ modules at 40 Gbit/s can also be used to provide four independent ports of 10 gigabit Ethernet. [1] 100G Transceiver Form Factors
Cisco Paging Server (InformaCast) - Paging/bell/mass notification system for CUCM. Originally developed by Singlewire Software, sold as a Cisco product. [22] Cisco Unified Communications Manager Express (CUCME) - a small scale/single server contact center solution; Cisco Unified Operations Manager (CUOM)— a NMS for voice.
A ready-to-use module is a complete system with a transceiver, and optionally an MCU and antenna on a printed circuit board. While most of the modules in this list are Zigbee , Thread , ISA100.11a , or WirelessHART modules, some don't contain enough flash memory to implement a Zigbee stack and instead run plain 802.15.4 protocol, sometimes with ...
The inside of a Cisco 1900-series switch. Catalyst is the brand for a variety of network switches, wireless controllers, and wireless access points sold by Cisco Systems.While commonly associated with Ethernet switches, a number of different types of network interfaces have been available throughout the history of the brand.
NG-PON2 (also known as TWDM-PON), Next-Generation Passive Optical Network 2 is a 2015 telecommunications network standard for a passive optical network (PON). The standard was developed by ITU and details an architecture capable of total network throughput of 40 Gbit/s, corresponding to up to 10 Gbit/s symmetric upstream/downstream speeds available at each subscriber.
An optical module is a typically hot-pluggable optical transceiver used in high-bandwidth data communications applications. Optical modules typically have an electrical interface on the side that connects to the inside of the system and an optical interface on the side that connects to the outside world through a fiber optic cable.
The physical coding sublayer (PCS) is a networking protocol sublayer in the Fast Ethernet, Gigabit Ethernet, and 10 Gigabit Ethernet standards. It resides at the top of the physical layer (PHY), and provides an interface between the physical medium attachment (PMA) sublayer and the media-independent interface (MII).
Texas Instruments – DP83848C PHY Data Sheet; hp.com – RGMIIv2_0_final_hp.pdf RGMII 2002-04-01 Version 2.0 ; Serial-GMII Specification Revision 1.7 (ENG-46158) (PDF), archived from the original (PDF) on 2015-07-14 "CEVA implementation documentation". Archived from the original on 2006-12-11. Altera 10 Gb Ethernet IP with XGMII and XAUI ...