Search results
Results from the WOW.Com Content Network
40G Transceiver Form Factors The QSFP+ form factor is specified for use with the 40 Gigabit Ethernet. Copper direct attached cable (DAC) or optical modules are supported, see Figure 85–20 in the 802.3 spec. QSFP+ modules at 40 Gbit/s can also be used to provide four independent ports of 10 gigabit Ethernet. [1] 100G Transceiver Form Factors
Small Form-factor Pluggable (SFP) is a compact, hot-pluggable network interface module format used for both telecommunication and data communications applications. An SFP interface on networking hardware is a modular slot for a media-specific transceiver , such as for a fiber-optic cable or a copper cable. [ 1 ]
The CFP transceiver is specified by a multi-source agreement (MSA) among competing manufacturers. [2] The CFP was designed after the small form-factor pluggable transceiver (SFP) interface, but is significantly larger to support 100 Gbit/s.
A ready-to-use module is a complete system with a transceiver, and optionally an MCU and antenna on a printed circuit board. While most of the modules in this list are Zigbee , Thread , ISA100.11a , or WirelessHART modules, some don't contain enough flash memory to implement a Zigbee stack and instead run plain 802.15.4 protocol, sometimes with ...
Cisco Paging Server (InformaCast) - Paging/bell/mass notification system for CUCM. Originally developed by Singlewire Software, sold as a Cisco product. [22] Cisco Unified Communications Manager Express (CUCME) - a small scale/single server contact center solution; Cisco Unified Operations Manager (CUOM)— a NMS for voice.
NG-PON2 (also known as TWDM-PON), Next-Generation Passive Optical Network 2 is a 2015 telecommunications network standard for a passive optical network (PON). The standard was developed by ITU and details an architecture capable of total network throughput of 40 Gbit/s, corresponding to up to 10 Gbit/s symmetric upstream/downstream speeds available at each subscriber.
An optical module is a typically hot-pluggable optical transceiver used in high-bandwidth data communications applications. Optical modules typically have an electrical interface on the side that connects to the inside of the system and an optical interface on the side that connects to the outside world through a fiber optic cable.
The original 2.94 Mbit/s Ethernet implementation had eight-bit addresses and other differences in frame format. [9] 10BASE5: 802.3-1985 (8) AUI, N, vampire tap: 500 m RG-8/U Original standard uses a single coaxial cable in which a connection is made by tapping into the single cable, drilling in to make contact with the core and the screen.