Search results
Results from the WOW.Com Content Network
Surge Protection Device (SPD) for installation in a low-voltage distribution board. A surge protector (or spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD), transient voltage suppressor (TVS) or transient voltage surge suppressor (TVSS)) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes ...
Vehicle lights provided the only illumination during the 2009 Ecuador electricity crisis.. A power outage, also called a powercut, a power out, a power failure, a power blackout, a power loss, a blackout or a power drought — is the loss of the electrical power network supply to an end user.
When an electrical conductor moves through a magnetic field, an electric current is induced into the conductor. The same thing also happens when the electrical conductor is stationary and the magnetic field is moving. This is known as electromagnetic induction, and is the underlying principle used in the construction of electrical generators.
Inrush current, input surge current, or switch-on surge is the maximal instantaneous input current drawn by an electrical device when first turned on. Alternating-current electric motors and transformers may draw several times their normal full-load current when first energized, for a few cycles of the input waveform.
In electrical engineering, overvoltage is the raising of voltage beyond the design limit of a circuit or circuit element. The conditions may be hazardous. The conditions may be hazardous. Depending on its duration, the overvoltage event can be transient —a voltage spike —or permanent, leading to a power surge.
Power system protection is a branch of electrical power engineering that deals with the protection of electrical power systems from faults [citation needed] through the disconnection of faulted parts from the rest of the electrical network. The objective of a protection scheme is to keep the power system stable by isolating only the components ...
A varistor (a.k.a. voltage-dependent resistor (VDR)) is a surge protecting electronic component with an electrical resistance that varies with the applied voltage. [2] It has a nonlinear, non-ohmic current–voltage characteristic that is similar to that of a diode. Unlike a diode however, it has the same characteristic for both directions of ...
It necessitates the test of surge immunity in electrical or electronic equipment. IEC 61000-4-5 defines test set-up, procedures, and classification levels. In particular, it standardizes the required surge voltage and current waveforms for laboratory testing, with the "1.2/50-8/20 μs" impulse being the most frequently used surge waveform.