Search results
Results from the WOW.Com Content Network
En-route charts are divided into high and low versions, with information on airways and navaids for high- and low-altitude flight, respectively. The division between low altitude and high altitude is usually defined as the altitude that marks transition to flight levels (in the United States , this is taken to be 18,000 feet MSL by convention).
High altitude airways (from 18,000 feet (5,500 m) MSL to FL450) based on VOR stations are called jet routes; they appear on high altitude charts (that usually do not show topography, as the low altitude charts do) and are prefixed by the letter "J". VOR-based routes are depicted in black on low and high altitude charts produced by the FAA's ...
An aeronautical chart is a map designed to assist in the navigation of aircraft, much as nautical charts do for watercraft, or a roadmap does for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful ...
The sectionals are complemented by terminal area charts (TACs) at 1:250,000 scale for the areas around major U.S. airports, and until 2016 by World Aeronautical Charts (WACs) at a scale of 1:1,000,000 for pilots of slower aircraft and aircraft at high altitude. [1] Since February 2021, the charts have been updated on a 56-day publication cycle. [2]
The rule affected only those aircraft operating under IFR when in level flight above 3,000 ft above mean sea level, or above the appropriate transition altitude, whichever is the higher, and when below FL195 (19,500 ft above the 1013.2 hPa datum in the UK, or with the altimeter set according to the system published by the competent authority in ...
An approach plate for the ILS or LOC approach to runway 14L at Cologne Bonn Airport, Germany.. Approach plates (or, more formally, instrument approach procedure charts) are the printed or digital charts of instrument approach procedures that pilots use to fly instrument approaches during instrument flight rules (IFR) operations.
T routes are low altitude RNAV only routes which may or may not utilize VOR NAVAIDS. The high altitude airways in the U.S. have names that start with the letter J and are called Jet Routes, or Q for Q routes. Q routes in the U.S. are RNAV only high altitude airways, whereas J routes use VOR NAVAID's the same way V routes do.
The initial altitude is sometimes stated on the charts. If not, it will be given by the air traffic controller. The departure frequency is given to the pilot when ATC hands the aircraft over to the next sector. A typical IFR clearance would be: OOABC, cleared to Ostend via the DENUT 7C departure, climb flight level six zero, squawk four six ...