Search results
Results from the WOW.Com Content Network
Amorphous silicon (a-Si) is the non-crystalline form of silicon used for solar cells and thin-film transistors in LCDs.. Used as semiconductor material for a-Si solar cells, or thin-film silicon solar cells, it is deposited in thin films onto a variety of flexible substrates, such as glass, metal and plastic.
As a material transitions from the amorphous state to the fully crystalline state, the broad maximum sharpens up and other sharp peaks start to appear in the n(λ) and k(λ) spectra. This is demonstrated for the case of amorphous silicon progressing to poly-silicon and further progressing to crystalline silicon.
Polycrystalline silicon, or multicrystalline silicon, also called polysilicon, poly-Si, or mc-Si, is a high purity, polycrystalline form of silicon, used as a raw material by the solar photovoltaic and electronics industry. Polysilicon is produced from metallurgical grade silicon by a chemical purification process, called the Siemens process.
A silicone oil is any liquid polymerized siloxane with organic side chains. The most important member is polydimethylsiloxane . These polymers are of commercial interest because of their relatively high thermal stability and their lubricating properties.
Si 24 is an orthorhombic crystalline Si allotrope.It was first synthesized in 2014. [5] [6] Creating the allotrope involved forming Na4 Si 24, a polycrystalline compound with help from a tantalum capsule, high temperature, and a 1,500 ton multi-anvil press that gradually reached a pressure of 10 gigapascals (1,500,000 psi).
Polycrystalline silicon (p-Si) is a pure and conductive form of the element composed of many crystallites, or grains of highly ordered crystal lattice.In 1984, studies showed that amorphous silicon (a-Si) is an excellent precursor for forming p-Si films with stable structures and low surface roughness. [2]
Amorphous steel is limited to foils of about 50 μm thickness. The mechanical properties of amorphous steel make stamping laminations for electric motors difficult. Since amorphous ribbon can be cast to any specific width under roughly 13 inches and can be sheared with relative ease, it is a suitable material for wound electrical transformer cores.
Directly behind the scintillator layer is an amorphous silicon detector array manufactured using a process very similar to that used to make LCD televisions and computer monitors. Like a TFT-LCD display, millions of roughly 0.2 mm pixels each containing a thin-film transistor form a grid patterned in amorphous silicon on the glass substrate. [1]