Ads
related to: hardinge 5c expanding collet work station tableuline.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
Hardinge, Inc. is a multi-national machine tool builder with global headquarters in Berwyn, PA, USA. It began operation in 1890. Hardinge is best known for its lathes, both non-CNC and CNC. Hardinge Inc. machine tool brands now include Hardinge, Bridgeport, Kellenberger, Usach, Hauser, Jones & Shipman, Voumard, and Tschudin. It currently has ...
A number of other C-series collets (1C, 3C, 4C, 5C, 16C, 20C & 25C) with different holding ranges also exist. A collet system with capabilities similar to the 5C (originally a proprietary system of Hardinge) is the 2J (originally a proprietary system of Sjogren, [12] a competitor of Hardinge, and which Hardinge later assimilated).
The collets have a precision bore with axial compression slots for holding cutting tools and are threaded for the drawbar. The R8 system is commonly used with collets ranging in size from 1 ⁄ 8 ″ to 3 ⁄ 4 ″ in diameter or tool holders with the same or slightly larger diameters. The collets or tool holders are placed directly into the ...
Hardinge, which was founded in the 1890s in Chicago and relocated to Elmira in the 1930s, sent a notice July 26 to employees of its Super-Precision division notifying them their employment would ...
Typical table sizes were 9″ × 49″ (Y and X, respectively) and 10″ × 54″. Machine tapers for tool holding included Morse tapers (on early models) and the R8 taper (a widely used standard that Bridgeport created) on most models. Both Morse and R8 allowed for both collets and solid holders, and a drill chuck could be held by either of ...
A machine with an R8 collet system (usually a manual Bridgeport style vertical mill, aiui) normally has a set of collets of varying sizes. To use a 1/2" shank end mill, you install the 1/2" collet, insert the end mill in the collet, and tighten the draw bar to retain the end mill. To use a different size tool, you use a different size collet.
A Swiss-style lathe holds the workpiece with both a collet and a guide bushing. The collet sits behind the guide bushing, and the tools sit in front of the guide bushing, holding stationary on the Z axis. To cut lengthwise along the part, the tools will move in and the material itself will move back and forth along the Z axis.
The drawbar pull is an important component that allows the milling machine to keep the tool in place while it’s being used. The force from the drawbar pull supplied to the tool has to be just right because not enough force would cause the tool to wobble leading to inaccuracy, and too much force would apply excessive stress, leading to shorter tool life.
Ads
related to: hardinge 5c expanding collet work station tableuline.com has been visited by 100K+ users in the past month