Search results
Results from the WOW.Com Content Network
German masons repointing a wall in 1948. Repointing is the process of renewing the pointing, which is the external part of mortar joints, in masonry construction. Over time, weathering and decay cause voids in the joints between masonry units, usually in bricks, allowing the undesirable entrance of water.
Mortar holding weathered bricks. Mortar is a workable paste which hardens to bind building blocks such as stones, bricks, and concrete masonry units, to fill and seal the irregular gaps between them, spread the weight of them evenly, and sometimes to add decorative colours or patterns to masonry walls.
Remember to thoroughly wet the brick prior to using lime mortar. Old brick can be extremely porous, a 4-pound (1.8 kg) brick can hold a 1 imperial pint (0.57 L) of water. The bricks should be saturated, but dry on the surface prior to laying or pointing. Excess water can cause the lime to run and leave streaks.
This joint is best used when the wall is intended to be plastered or joints are to be hidden under paint. Because the mortar is not compressed, it is less water-resistant than some of the other designs. Tuckpointing This joint has mortar colored to match the bricks surrounding a line of white mortar to make the joints look very small.
The International Union of Bricklayers and Allied Craftworkers (BAC) is a labor union in the United States and Canada which represents bricklayers, restoration specialists, pointers/cleaners/caulkers, stonemasons, marble masons, cement masons, plasterers, tile setters, terrazzo mechanics, and tile, marble and terrazzo finishers.
Tabby was used in place of bricks, which could not be made locally because of the absence of local clay. Tabby was used like concrete for floors, foundations, columns, roofs. Besides replacing bricks, it was also used as "oyster shell mortar" or "burnt shell mortar".
Tuckpointing was a way of achieving a similar effect using cheap, unrubbed bricks; these were laid in a mortar of a matching colour (initially red, but later, blue-black bricks and mortar were occasionally used) and a fine fillet of white material, usually pipe clay or putty, pushed into the joints before the mortar set. [4]
Cement render or cement plaster is the application of a mortar mix of sand and cement, (optionally lime) and water to brick, concrete, stone, or mud brick. It is often textured, colored, or painted after application. It is generally used on exterior walls but can be used to feature an interior wall. [1]