Search results
Results from the WOW.Com Content Network
Dry running protection, also known as dry-run protection or dry-running protection, is a type of protection mechanism to prevent a rotor, pump or stirrer shaft from operating without any medium added, as the bearing and shaft seal might be damaged if the motor is run while dry. [1]
Small compressed air powered breathing gas booster pump Haskell booster set up for charging rebreather cylinders from premix banks with low pressure compressor. A booster pump is a machine which increases the pressure of a fluid. It may be used with liquids or gases, and the construction details vary depending on the fluid.
Pressure-retaining items can be registered with the National Board, requiring certain uniform quality standards be achieved certifying the manufacturing, testing, and inspection process. To obtain a certification the registered items have to be inspected by National Board-commissioned inspectors and built to required standards.
[c] These are supplementary pumps and do not replace the main, mechanical, oil pump. Electric pump as a main engine pump again will require big electric motors and it may be simply cheaper to drive directly from the engine. For e.g. BMW S65 engine's oil pump delivers ca. 45 LPM (Litres Per Minute) of oil at 5.5 bar pressure. [5]
A pedestal sump pump with a float switch. A float switch is a type of level sensor, a device used to detect the level of liquid within a tank. The switch may be used to control a pump, as an indicator, an alarm, or to control other devices. One type of float switch uses a mercury switch inside a hinged float.
If an NPSH A is say 10 bar then the pump you are using will deliver exactly 10 bar more over the entire operational curve of a pump than its listed operational curve. Example: A pump with a max. pressure head of 8 bar (80 metres) will actually run at 18 bar if the NPSH A is 10 bar. i.e.: 8 bar (pump curve) plus 10 bar NPSH A = 18 bar.
The motor constant is winding independent (as long as the same conductive material is used for wires); e.g., winding a motor with 6 turns with 2 parallel wires instead of 12 turns single wire will double the velocity constant, , but remains unchanged.
The control equipment for jockey pumps may however carry approvals. Jockey pumps should be sized for 3% of the flow of the main fire pump and to provide 10psi more pressure than the main fire pump (As per Code IS 15105 : 2002) In the United States, the application of a jockey pump in a fire protection system is provided by NFPA 20.