Search results
Results from the WOW.Com Content Network
e. Knob-and-tube wiring (sometimes abbreviated K&T) is an early standardized method of electrical wiring in buildings, in common use in North America from about 1880 to the 1930s. [1][2] It consisted of single-insulated copper conductors run within wall or ceiling cavities, passing through joist and stud drill-holes via protective porcelain ...
The gusset plate is usually painted to match nearby steel and fixtures and to give it an extra layer of protection. [2] Occasionally gusset plates are made from copper or aluminum, but only with small structures that do not require much support. The copper and aluminum gusset plates also provide a more attractive finish for exposed structures. [2]
A fire-tube boiler is a type of boiler invented in 1828 by Mark Seguin, [1] in which hot gases pass from a fire through one or more tubes running through a sealed container of water. The heat of the gases is transferred through the walls of the tubes by thermal conduction , heating the water and ultimately creating steam .
Electric heat tracing, heat tape or surface heating, is a system used to maintain or raise the temperature of pipes and vessels using heat tracing cables. Trace heating takes the form of an electrical heating element run in physical contact along the length of a pipe. The pipe is usually covered with thermal insulation to retain heat losses ...
The fire-tubes are arranged in a single horizontal group above this, mounted between two flat vertical plates that are inset into the boiler barrel. The first of these plates forms a shallow combustion chamber and is connected to the firebox by a short diagonal neck. The combustion chamber is of the "dry back" form and is closed by a steel and ...
Conductor cross section area is 1.5 mm 2; overall diameter is 7.2 mm. Mineral-insulated copper-clad cable is a variety of electrical cable made from copper conductors inside a copper sheath, insulated by inorganic magnesium oxide powder. The name is often abbreviated to MICC or MI cable, and colloquially known as pyro (because the original ...
Heat exchangers using copper and its alloys have evolved along with heat transfer technologies over the past several hundred years. Copper condenser tubes were first used in 1769 for steam engines. Initially, the tubes were made of unalloyed copper. By 1870, Muntz metal, a 60% Cu-40% Zn brass alloy, was used for condensers in seawater cooling.
Heat-shrink tubing (or, commonly, heat shrink or heatshrink) is a shrinkable plastic tube used to insulate wires, providing abrasion resistance and environmental protection for stranded and solid wire conductors, connections, joints and terminals in electrical wiring. It can also be used to repair the insulation on wires or to bundle them ...