Search results
Results from the WOW.Com Content Network
For instance, to safely fill a new container or a pressure vessel with flammable gases, the atmosphere of normal air (containing 20.9 volume percent of oxygen) in the vessel would first be flushed (purged) with nitrogen or another non-flammable inert gas, thereby reducing the oxygen concentration inside the container. When the oxygen ...
The system can be flushed with an inert gas to reduce the concentration of oxygen so that when the flammable gas is admitted, an ignitable mixture cannot form. In NFPA 56, [1] this is known as purge-into-service. In combustion engineering terms, the admission of inert gas dilutes the oxygen below the limiting oxygen concentration.
An aerosol must be assigned to Division 2.1 if it is deemed flammable in accordance with the appropriate tests of the UN Manual of Tests and Criteria for flammability. Division 2.2: Non-Flammable, Non-Toxic Gas This division includes compressed gas, liquefied gas, pressurized cryogenic gas, compressed gas in solution, asphyxiant gas and ...
Controlling gas and vapor concentrations outside the flammable limits is a major consideration in occupational safety and health. Methods used to control the concentration of a potentially explosive gas or vapor include use of sweep gas, an unreactive gas such as nitrogen or argon to dilute the explosive gas before coming in contact with air.
Anyone evacuating their homes due to the fire can go to the following locations, according to Cal Fire: Westwood Recreation Center - 1350 S. Sepulveda Blvd., Los Angeles, California, 90025
This is a list of Superfund sites in Pennsylvania designated under the Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA) environmental law.The CERCLA federal law of 1980 authorized the United States Environmental Protection Agency (EPA) to create a list of polluted locations requiring a long-term response to clean up hazardous material contaminations. [1]
Consider the first triangular diagram below, which shows all possible mixtures of methane, oxygen and nitrogen. Air is a mixture of about 21 volume percent oxygen, and 79 volume percent inerts (nitrogen). Any mixture of methane and air will therefore lie on the straight line between pure methane and pure air – this is shown as the blue air-line.
The cheap and freely available gas has a molecular weight and fragmentation pattern (base peak 51 m/z in typical EI-MS, [7] major peak at 65 m/z) distinct from anything in air. If mass peaks corresponding to 1,1-difluoroethane are observed immediately after spraying a suspect leak point, leaks may be identified.