Search results
Results from the WOW.Com Content Network
Surface plate. A 250 mm x 250 mm surface plate. A surface plate is a solid, flat plate used as the main horizontal reference plane for precision inspection, marking out (layout), and tooling setup. [1] The surface plate is often used as the baseline for all measurements to a workpiece, therefore one primary surface is finished extremely flat ...
Timber sills can span gaps in a foundation. A sill plate or sole plate in construction and architecture is the bottom horizontal member of a wall or building to which vertical members are attached. The word "plate" is typically omitted in America and carpenters speak simply of the "sill". Other names are rat sill, ground plate, ground sill ...
The base plate or floor plate is the bottom attachment point for the wall studs. Using a top plate and a bottom plate, a wall can be constructed while it lies on its side, allowing for end-nailing of the studs between two plates, and then the finished wall can be tipped up vertically into place atop the wall sill; this not only improves ...
Gusset plate. In structural engineering and construction, a gusset plate is a plate for connecting beams and girders to columns. A gusset plate can be fastened to a permanent member either by bolts, rivets or welding or a combination of the three. [1] They are used in bridges and buildings, as well as other structures.
A base metal is a common and inexpensive metal, as opposed to a precious metal such as gold or silver. [1] In numismatics , coins often derived their value from the precious metal content; however, base metals have also been used in coins in the past and today.
The tie plate increases bearing area and holds the rail to correct gauge. It is fastened to wooden ties by means of spikes or bolts through holes in the plate. The part of the plate under the rail base is tapered, setting the inboard cant of the rail, typically "one in forty" (or 1.4 degrees ). The top surface of the plate has one or two ...
A base jack or plate which is a load-bearing base for the scaffold. The standard, the upright component with connector joins. The ledger, a horizontal brace. The transom, a horizontal cross-section load-bearing component which holds the batten, board, or decking unit. Brace diagonal and/or cross section bracing component.
Theodolite. A direct-readout theodolite, manufactured in the Soviet Union in 1958 and used for topographic surveying. A theodolite (/ θiˈɒdəˌlaɪt /) [1] is a precision optical instrument for measuring angles between designated visible points in the horizontal and vertical planes. The traditional use has been for land surveying, but it is ...