Search results
Results from the WOW.Com Content Network
The memory cell is the fundamental building block of computer memory. The memory cell is an electronic circuit that stores one bit of binary information and it must be set to store a logic 1 (high voltage level) and reset to store a logic 0 (low voltage level). Its value is maintained/stored until it is changed by the set/reset process.
Without knowing the clock frequency it is impossible to state if one set of timings is "faster" than another. For example, DDR3-2000 memory has a 1000 MHz clock frequency, which yields a 1 ns clock cycle. With this 1 ns clock, a CAS latency of 7 gives an absolute CAS latency of 7 ns. Faster DDR3-2666 memory (with a 1333 MHz clock, or 0.75 ns ...
In a computer using virtual memory, accessing the location corresponding to a memory address may involve many levels. In computing, a memory address is a reference to a specific memory location in memory used by both software and hardware. [1] These addresses are fixed-length sequences of digits, typically displayed and handled as unsigned ...
PC2-5300 DDR2 SO-DIMM (for notebooks) Comparison of memory modules for desktop PCs (DIMM) Comparison of memory modules for portable/mobile PCs (SO-DIMM) The key difference between DDR2 and DDR SDRAM is the increase in prefetch length. In DDR SDRAM, the prefetch length was two bits for every bit in a word; whereas it is four bits in DDR2 SDRAM.
A common example is the Data General Nova, which was a 16-bit design that performed 16-bit math as a series of four 4-bit operations. 4-bits was the word size of a widely available single-chip ALU and thus allowed for inexpensive implementation. Using the definition being applied to the 68000, the Nova would be a 4-bit computer, or 4/16.
A 32-bit register can store 2 32 different values. The range of integer values that can be stored in 32 bits depends on the integer representation used. With the two most common representations, the range is 0 through 4,294,967,295 (2 32 − 1) for representation as an binary number, and −2,147,483,648 (−2 31) through 2,147,483,647 (2 31 − 1) for representation as two's complement.
Two memory interfaces per module is a common configuration for PC system memory, but single-channel configurations are common in older, low-end, or low-power devices. Some personal computers and most modern graphics cards use more than two memory interfaces (e.g., four for Intel's LGA 2011 platform and the NVIDIA GeForce GTX 980).
A model, called Concurrent-AMAT (C-AMAT), is introduced for more accurate analysis of current memory systems. More information on C-AMAT can be found in the external links section. AMAT's three parameters hit time (or hit latency), miss rate, and miss penalty provide a quick analysis of memory systems. Hit latency (H) is the time to hit in the ...