enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Slide hammer - Wikipedia

   en.wikipedia.org/wiki/Slide_Hammer

   A slide hammer is a tool that attaches to an object needing to be pulled and transmits an impact force to the object without striking the object itself. Slide hammers typically consist of a long metal shaft with an attachment point at one end, a heavy weight that can slide along the shaft , and a stop for the weight to impact on the end ...

3. Constant-velocity joint - Wikipedia

   en.wikipedia.org/wiki/Constant-velocity_joint

   A Rzeppa-type CV joint. A constant-velocity joint (also called a CV joint and homokinetic joint) is a mechanical coupling which allows the shafts to rotate freely (without an appreciable increase in friction or backlash) and compensates for the angle between the two shafts, within a certain range, to maintain the same velocity.

4. Spike puller - Wikipedia

   en.wikipedia.org/wiki/Spike_puller

   Spike pullers are self-propelled by a diesel engine and travel along the railroad tracks. A typical spike puller is a small, two axle machine. Most spike pullers are designed only to remove spikes on one side of the tracks, meaning that two machines must be used together to remove all the spikes from both rails.

5. Impact driver - Wikipedia

   en.wikipedia.org/wiki/Impact_driver

   A manual impact driver (for use with hammer) with screwdriver bits and adapters. An impact driver is a tool that delivers a strong, sudden rotational force and forward thrust. The force can be delivered either by striking with a hammer in the case of manual impact drivers, or mechanically in the case of powered impact drivers.

6. Easco Hand Tools - Wikipedia

   en.wikipedia.org/wiki/Easco_Hand_Tools

   Easco Hand Tools was an American manufacturer of hand tools. It is best known for being the main supplier of mechanic's tools for the Craftsman brand. Its tools were also sold under the Allen and KD Tools brands after its acquisition by Danaher Corporation. The brand name was gradually phased out by Danaher.

7. Screw extractor - Wikipedia

   en.wikipedia.org/wiki/Screw_extractor

   The screw is drilled out with the appropriate drill and drill bushing. The extractor is then hammered into the hole with a brass hammer, because a steel hammer is more likely to cause the extractor to break. The appropriate special nut is then attached to the end of the extractor. The nuts can then be turned with a wrench to remove the screw. [1]