Ads
related to: stroker engine for cars partsjbugs.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
The induction stroke is the first phase in a four-stroke (e.g. Otto cycle or Diesel cycle) engine.It involves the downward movement of the piston, creating a partial vacuum that draws an air-fuel mixture (or air alone, in the case of a direct injection engine) into the combustion chamber.
While similar in displacement to the other 4.3–4.4 L (265–267 cu in) V8 engines produced by General Motors (including the Oldsmobile 260 and Pontiac 265), the small bore 267 shared no parts with the other engines and was phased out after the 1982 model year due to inability to conform to emission standards. Chevrolet vehicles eventually ...
The distance between the axis of the crankpins and the axis of the crankshaft determines the stroke length of the engine. [1] Most modern car engines are classified as "over square" or short-stroke, [citation needed] wherein the stroke is less than the diameter of the cylinder bore. A common way to increase the low-RPM torque of an engine is to ...
There are many stroker kits available for RB engines (some only available as proper kits while others being achievable by using cranks from other engines, for example a GT-R crank, pistons and rods in an RB25DET will make its displacement 2.6L as the bore is the same as an RB26DETT). Achievable stroker displacements for RB engines: RB20 - 2.2, 2.4
The 122 engine was designed by Chevrolet and was used in a wide array of General Motors vehicles. The 122 was similar to the first two generations of the General Motors 60° V6 engine; sharing cylinder bore diameters and some parts. [citation needed] The 122 was available in the U.S. beginning in 1982 for the GM J platform compact cars and S ...
The Chrysler Slant-Six is the popular name for an overhead valve inline-6 engine produced by Chrysler Motors between 1959 and 2000. Featuring a reverse-flow cylinder head and cylinder bank inclined at a 30-degree angle from vertical, it was introduced in 170 cu in (2.8 L) and 225 cu in (3.7 L) displacements for the 1960 model year.
The engine is informally known as the HiPo or the "K-code" (after the engine letter used in the VIN code of cars so equipped). It was the only 289 engine available in the intermediate Fairlanes, with lesser-powered cars receiving the 260 V8. Starting in June 1964, it became an option for the Mustang. The HiPo engine was engineered to increase ...
The first Y-block on Ford automobiles and F100 trucks was the 239 cu in (3,910 cc) version as released in 1954 with EBU casting numbers. The Y-block was the same displacement as the old Ford Flathead V8 that it replaced but with a bigger bore and a shorter stroke (3.5 x 3.1 in).
Ads
related to: stroker engine for cars partsjbugs.com has been visited by 10K+ users in the past month