Search results
Results from the WOW.Com Content Network
He did not change the subdivisions (1 inch = 12 subdivisions = 72 points), but defined it strictly in terms of the royal foot, a legal length measure in France: the Didot point is exactly 1 ⁄ 864 of a French foot or 1 ⁄ 72 of a French inch, that is (by 1799) 15 625 ⁄ 41 559 mm or about 0.375 972 mm. Accordingly, one Didot point is exactly ...
The traditional typographic units are based either on non-metric units, or on odd multiples (such as 35 ⁄ 83) of a metric unit.There are no specifically metric units for this particular purpose, although there is a DIN standard sometimes used in German publishing, which measures type sizes in multiples of 0.25 mm, and proponents of the metrication of typography generally recommend the use of ...
medium-bore refers to calibers with a diameter of 0.33 inches (8.4 mm) to 0.39 inches (9.9 mm) large-bore refers to calibers with a diameter of 0.40 inches (10 mm) or larger There is much variance in the use of the term "small-bore", which over the years has changed considerably, with anything under 0.577 inches (14.7 mm) considered "small-bore ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
The United States retained the 1 / 39.37 -metre definition for surveying, producing a 2 millionth part difference between standard and US survey inches. [47] This is approximately 1 / 8 inch per mile; 12.7 kilometres is exactly 500,000 standard inches and exactly 499,999 survey inches.
The major minus pitch also works for inch-based threads, but you must first determine the pitch by looking at the number of treads per inch (TPI; for example, 1 ⁄ 20 = 0.050 and 1 ⁄ 13 ≈ 0.077), and your result will only land near a tap drill size (not directly on one).
Engine power was increased again by reducing engine stroke by 0.375 inches, increasing the rpm. [9] The Orchard 620 or O-620 used the new 620 engine and remained in production after the 630 was introduced. It was the only "20" series tractor in production after 1958. [2] [10]
The magnetic stripe is located 0.223 inches (5.7 mm) from the edge of the card, and is 0.375 inches (9.5 mm) wide. The magnetic stripe contains three tracks, each 0.110 inches (2.8 mm) wide. Tracks one and three are typically recorded at 210 bits per inch (8.27 bits per mm), while track two typically has a recording density of 75 bits per inch ...