Search results
Results from the WOW.Com Content Network
In an internal combustion engine, the engine block is the structure that contains the cylinders and other components. The engine block in an early automotive engine consisted of just the cylinder block, to which a separate crankcase was attached. Modern engine blocks typically have the crankcase integrated with the cylinder block as a single ...
1919 Napier Lion II aircraft engine with three cylinder banks. Any design of motor/engine,be it a V or a boxer can be called an "in-line" if it's mounted in-line with the frame/chassis and in-line with the direction of travel of the vehicle.When the motor/engine is across the frame/chassis this is called a TRANSVERSE motor.Cylinder arrangement is not in the description of how the motor/engine ...
All engines in this family share the same block dimensions and sometimes even the same casting number; the latter meaning engines were of the same block, but with different strokes (e.g., the casting number 3970010 was used by all three engines: 302, 327, and 350).
Do not confuse with later AMC 2.5 L engine that uses GM small corporate pattern . Chevrolet Turbo-Thrift engine (post-1962) Chevrolet 153 Inline 4 (Chevy II, pre-Iron-Duke - includes the Vortec 3000/181 industrial/marine crate motor) Detroit Diesel V8 6.2L and 6.5L; Duramax V8; Generation III V8s with modifications. These modifications include ...
The first Y-block on Ford automobiles and F100 trucks was the 239 cu in (3,910 cc) version as released in 1954 with EBU casting numbers. The Y-block was the same displacement as the old Ford Flathead V8 that it replaced but with a bigger bore and a shorter stroke (3.5 x 3.1 in).
The base of a reciprocating internal combustion engine is the engine block, which is typically made of cast iron (due to its good wear resistance and low cost) [22] or aluminum. In the latter case, the cylinder liners are made of cast iron or steel, [23] or a coating such as nikasil or alusil. The engine block contains the cylinders.
The numeric engine referencing system used until the mid-1980s was simply the chronological sequence of engine development projects. Thus, variants based on the same engine block may have unrelated numbers.
The engine was available through mid-1965, when it was replaced by the 396 cu in (6.5 L) 375 hp (280 kW) Mark IV big-block engine. In addition, a 340 hp (254 kW) version of the 409 engine was available from 1963 to 1965, with a single 4-barrel cast iron intake mounting a Rochester 4GC square-bore carburetor, and hydraulic lifters .