Search results
Results from the WOW.Com Content Network
In a typical CVT, the gear ratio will be chosen so the engine can reach and maintain its maximum-power speed as soon as possible (or at least, when at full throttle, in a partially load-dependent system), but in a semi-auto, the rider is responsible for this choice, and they can ride around all day in top gear (or first) if they so prefer.
With power typically being the product of force and speed, a motorcycle's power and torque ratings will be highly indicative of its performance. Reported numbers for power and torque may however vary from one source to another due to inconsistencies in how testing equipment is calibrated, the method of using that equipment, the conditions during the test, and particularly the location that ...
Typical gear ratios on bicycles range from very low or light gearing around 20 gear inches (1.6 metres per revolution), via medium gearing around 70 gear inches (5.6 m), to very high or heavy gearing around 125 gear inches (10 m). As in a car, low gearing is for going up hills and high gearing is for going fast.
A mechanical transmission with a selection of different gear ratios is designed to make satisfactory power available over the full range of vehicle speeds. The goal of the selection of gear ratios is to keep the engine operating in its power band. The narrower the band, the more gears are needed, closer together in ratio.
Bicycle and motorcycle geometry is the collection of key measurements (lengths and angles) that define a particular bike configuration. Primary among these are wheelbase , steering axis angle, fork offset, and trail.
At the start of a race it takes between one and two seconds for the motorcycle to reach the "curve speed" (somewhat lower than the average), which is roughly estimated to be the equivalent of 2.5 to 3 seconds to reach 100 kilometres per hour (62 mph) (or 0 to 60 mph). The start of the race is an important aspect of the race overall.
Gear shift lever on a motorcycle (above the toe of the rider's boot) A sequential manual transmission is unsynchronized, and allows the driver to select either the next gear (e.g. shifting from first gear to second gear) or the previous gear (e.g., shifting from third gear to second gear), operated either via electronic paddle-shifters mounted behind the steering wheel or with a sequential ...
Power-to-weight ratio (PWR, also called specific power, or power-to-mass ratio) is a calculation commonly applied to engines and mobile power sources to enable the comparison of one unit or design to another. Power-to-weight ratio is a measurement of actual performance of any engine or power source.