Search results
Results from the WOW.Com Content Network
Tilted block faulting, also called rotational block faulting, is a mode of structural evolution in extensional tectonic events, a result of tectonic plates stretching apart. [ 1 ] [ 2 ] When the upper lithospheric crust experiences extensional pressures, the brittle crust fractures, creating detachment faults . [ 3 ]
Fault-block mountain of the tilted type. [16] Sierra Nevada Mountains (formed by delamination) as seen from the International Space Station. When a fault block is raised or tilted, a block mountain can result. [17] Higher blocks are called horsts, and troughs are called grabens. A spreading apart of the surface causes tensional forces.
Lifted fault-block geology Tilted fault-block formation in the Teton Range. Fault-block mountains often result from rifting, an indicator of extensional tectonics. These can be small or form extensive rift valley systems, such as the East African Rift zone. Death Valley in California is a smaller example.
With crustal extension, a series of normal faults which occur in groups, form in close proximity and dipping in opposite directions. [4] As the crust extends it fractures in series of fault planes, some blocks sink down due to gravity, creating long linear valleys or basins also known as grabens, while the blocks remaining up or uplifted produce mountains or ranges, also known as horsts.
These normal faults, in this view, are steep near the surface but become low angle at depth; the mountain blocks rotated as they slid to produce the tilted mountains seen today. [17] Total movement of the Pamamint block between the Garlock and Furnace Creek Faults is 50 miles (80 km) to the northwest, giving birth to Death Valley in the process ...
A graben is a section of crust that has lowered relative to the blocks on either side, which is a result of its bounding faults dipping towards each other. [2] The plural of graben can be either graben or grabens. Graben form low-lying features such as basins and rift valleys. [1] [2] They can be very long relative to their width.
Fault lines are fractures between blocks of rock in the Earth’s crust, the layer closest to the surface. These lines allow tectonic plates to move and earthquakes occur when two plates slide ...
They range in width from somewhat less than 100 km up to several hundred km, consisting of one or more normal faults and related fault blocks. [2] In individual rift segments, one polarity (i.e. dip direction) normally dominates, giving a half-graben geometry. [6] Other common geometries include metamorphic core complexes and tilted blocks.