Search results
Results from the WOW.Com Content Network
A diagram showing the wiring of a Gibson Les Paul electric guitar. Shown are the humbucker pickups with individual tone and volume controls (T and V, respectively), 3-way pickup selector switch, tone capacitors that form a passive low-pass filter, the output jack and connections between those components. The top right shows a modification that ...
Spur circuits attached to the ring can overheat if not fused at the spur-point (i.e., if a BS 5733 or similar fused spur is not used) This is almost certainly a breach of the appropriate electrical standards (e.g. BS 7671 in the UK): the maximum load on any unfused spur is a single fitting.
Many accessories for electrical installations (e.g., wall sockets, switches) sold in the UK are designed to fit into the mounting boxes defined in BS 4662:2006—Boxes for flush mounting of electrical accessories—Requirements, test methods and dimensions, with an 86 mm × 86 mm square face plate that is fixed to the rest of the enclosure by ...
The fuse in the plug would be sized to protect the flexible cord for over-current. Wired connections may also be connected to the final ring, requiring to include a suitably rated fuse and switch. The final ring circuit in the UK requires the use of BS 1363 plugs and sockets.
In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...
In 1955 the model became the ES-5 Switchmaster, which incorporated a four-position selector switch, along with a new six-knob configuration, incorporating a volume and a tone knob for each pickup. The ES-5 Switchmaster was produced until 1962. [3] It remained out of production until a 1995 reissue from the Gibson Custom division.
The second, introduced in 1983, added an on/off switch and a more powerful drive. The third, introduced in 1989, had improved sensitivity and faster attack. The EBow Plus, introduced in 1998, adds a blue LED and a switch to allow users to move between normal and harmonic modes (which sounds one octave higher). [4] It is powered by a nine-volt ...
The effect (now named Uni-Vibe) was modified to have easier access to its fuse, and a speed control foot pedal was added. It was later released in North America by Univox in 1968. [1] [3] It is commonly thought the Uni-Vibe is intended to emulate the "Doppler sound" of a Leslie speaker. However Fumio Mieda revealed in an interview the effect ...