Ads
related to: best amplifier for electrostatic speakers on the market for sale craigslistcrutchfield.com has been visited by 100K+ users in the past month
- Home Speakers
From Bookshelf Speakers to Floor
Standing Towers, Shop Great Sound
- A/V Receivers
Power for All Your Speakers and
Connections for All Your A/V Gear
- Home Audio Specials
Shop Our Weekly Specials for Big
Savings on Top Electronics Gear
- Turntables
Check Out Our Wide Selection From
Entry-Level to Audiophile-Grade
- Home Speakers
Search results
Results from the WOW.Com Content Network
This article lists manufacturers of bass amplifiers, loudspeakers, and other amplification-related items such as preamplifiers. The amplifiers and loudspeakers used to amplify bass instruments (e.g., the bass guitar, double bass and similar instruments) are distinct from other types of amplification systems due to the particular challenges associated with low-frequency sound reproduction.
The amplifier's main appeal was its inherent musicality, its ability to drive difficult speaker loads, and to allow audiophile grade source components to excel. [ 2 ] [ 3 ] Launching the product in the US at the Consumer Electronics Show, the company wired up a battery of loudspeakers in a way which presented an impedance of 1.1 ohm, and the ...
The first product Naim put on the market was the NAP160 power amplifier; it was followed by the NAC12 pre-amplifier. [1] The two-channel NAP 250 amplifier, launched in 1975, is perhaps Naim Audio's most well-known analogue product, as its basic circuit layout was shared by all the company's power amplifiers until the introduction of the NAP500 in 2000.
PMC speakers: United Kingdom Polk Audio: United States ProAc: United Kingdom PSB Speakers: Canada QSC Audio Products: United States Quad Electroacoustics: United Kingdom (brand) Radio Shack: United States RCF audio: Italy Rectilinear Research Corporation: United States Rega Research: United Kingdom Renkus-Heinz: United States ReVox: Switzerland ...
Naim power amplifiers are given numbers according to their power output into nominal load of 4 ohms. The company's first amplifier, the NAP 160, is a two-channel power amplifier with an output of 60 watts per channel; the NAP 135, which is a one-channel amplifier based on the same design as the NAP 250 rated at 135 watts. A custom-built very ...
ML-2, a Class A Mono Amplifier with 25 Watts output power at 8 Ohms, regulated power supply for output section and modular construction. ML-3, a Class AB Power Amplifier with 2 x 200 Watts output power at 8 Ohms in a dual mono construction. ML-9, a Class AB Power Amplifier with 2 x 100 Watts output power at 8 Ohms.
Since the 1990s a niche market has developed again in the west for low-power commercial SET amplifies (up to 7 watts), notably using the 300B valve in recent years, which has become fashionable and expensive. Lower-power amplifiers based on other vintage valve types such as 2A3 and 45 are also made.
The first fully successful full-range electrostatic speaker, and also among the most influential, was produced in 1957: the Quad Electrostatic Loudspeaker (Quad ESL, later known as the ESL-57) from Quad Electroacoustics, of Huntingdon, England. These were shaped somewhat like a home electric radiator curved slightly on the vertical axis.
Ads
related to: best amplifier for electrostatic speakers on the market for sale craigslistcrutchfield.com has been visited by 100K+ users in the past month