enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Parallel rulers - Wikipedia

   en.wikipedia.org/wiki/Parallel_rulers

   Parallel rule in plastic with aluminum arms lying on a cutting mat. Parallel rulers are a drafting instrument used by navigators to draw parallel lines on charts. The tool consists of two straight edges joined by two arms which allow them to move closer or further away while always remaining parallel to each other.

3. T-square - Wikipedia

   en.wikipedia.org/wiki/T-square

   T-squares are available in a range of sizes, with common lengths being 18 inches (460 mm), 24 inches (610 mm), 30 inches (760 mm), 36 inches (910 mm) and 42 inches (1,100 mm). [ citation needed ] In addition to drawing horizontal lines, a T-square can be used with a set square to draw vertical or diagonal lines. [ 1 ]

4. Technical drawing tool - Wikipedia

   en.wikipedia.org/wiki/Technical_drawing_tool

   [6]: 35–36 A drafting machine allows easy drawing of parallel lines over the paper. The adjustable angle between the rulers allows the lines to be drawn in varying accurate angles. Rulers may also be used as a support for separate special rulers and letter templates. The rules are replaceable and they can be for example scale-rules.

5. Technical drawing - Wikipedia

   en.wikipedia.org/wiki/Technical_drawing

   Modern drafting tables are equipped with a drafting machine that is supported on both sides of the table to slide over a large piece of paper. Because it is secured on both sides, lines drawn along the edge are guaranteed to be parallel. [3] The drafter uses several technical drawing tools to draw curves and circles.

6. Engineering drawing abbreviations and symbols - Wikipedia

   en.wikipedia.org/wiki/Engineering_drawing...

   computer-aided design, computer-aided drafting; cadmium [plating] CAGE: Commercial and Government Entity [code] A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing. One corporation can have many CAGE codes ...

7. Parallel (engineering) - Wikipedia

   en.wikipedia.org/wiki/Parallel_(engineering)

   A parallel is a rectangular block of metal, commonly made from tool steel, stainless steel or cast iron, which has 2, [1] 4 or 6 faces ground or lapped to a precise ...

8. Zou Jingyuan defends parallel bars title at Paris Olympics ...

   www.aol.com/news/zou-jingyuan-defends-parallel...

   The King of Parallel Bars was close to perfection Monday to defend his Olympic title on the apparatus on the final day of artistic gymnastics at the Paris Games. It was a rare feat from Zou, who ...

9. Square (tool) - Wikipedia

   en.wikipedia.org/wiki/Square_(tool)

   The stock is usually thicker than the blade, with the blade being fixed into or onto the stock. The blade typically has parallel edges. The stock is usually held against the edge of a workpiece or drawing board and the tongue is then used as a straight edge for making a mark, or as a reference to check the accuracy of an angle.