Search results
Results from the WOW.Com Content Network
A cable tester is an electronic device used to verify the electrical connections in a signal cable or other wired assembly. Basic cable testers are continuity testers that verify the existence of a conductive path between ends of the cable, and verify the correct wiring of connectors on the cable. More advanced cable testers can measure the ...
DC testing has also been shown to reduce the remaining life of cables with aged polymer insulation. [1] VLF testing of cables is supported in IEC 60502 (up to 35 kV) and in IEEE 400.2 (up to 69 kV). As higher voltage VLF equipment is developed, standards may be adapted to increase the voltage level for application.
T1000-37 Tesuto Breakout box employing commonly used 37 position D-sub connectors that break out to banana jack test points. A four-port serial (RS-232) PCI Express ×1 expansion card with an octopus cable that breaks the card's DC-37 connector into four standard DE-9 connectors Example of a pocket-sized RS-232 breakout box that features switches to reconfigure or patch any or all the active ...
Entry-level cable testers are essentially continuity testers. A continuity tester is an item of electrical test equipment used to determine if an electrical path can be established between two points; [1] that is if an electrical circuit can be made. The circuit under test is completely de-energized prior to connecting the apparatus. [1]
Murray loop test employs the principle of wheatstone bridge for locating the fault. To perform this test, it is necessary to have a sound cable running alongside the faulty cable. One end of the faulted cable is connected through a pair of resistors to the voltage source. Also a null detector is connected. The other end of the cable is shorted.
IEC 62057-1 Electrical energy meters – Test equipment, techniques and procedures – Part 1: Stationary meter test units (MTUs) IEC 62057-3 Electrical energy meters – Test equipment, techniques and procedures – Part 3: Automatic meter testing system (AMTS) IEC 62058 Electricity metering equipment (AC) – Acceptance inspection
A full-sized to-scale wiring diagram can be made of a cable harness. This wiring diagram can then be laid on a peg board and used to guide the construction of more cable harnesses. Harnesses can be inserted into their equipment as an assembly. Cable harnesses that are reused many times, like automobile wiring harnesses, are created with ...
Creates constant-amplitude variable frequency sine waves to test frequency response Transistor tester: Tests transistors Tube tester: Tests vacuum tubes (triode, tetrode etc.) Wattmeter: Measures power in a circuit Vectorscope: Displays the phase of the colors in color TV Video signal generator: Generates video signal for testing purposes Voltmeter