Ad
related to: plywood sizes in mm measurements sheet
Search results
Results from the WOW.Com Content Network
The sizes of the most commonly used plywood sheets are 4 by 8 feet (1,220 mm × 2,440 mm) [20] which was first used by the Portland Manufacturing Company, who developed modern veneer core plywood for the 1905 Portland World Fair. A common metric size for a sheet of plywood is 1200 × 2400 mm. 5 × 5 feet (1,500 × 1,500 mm) is also a common ...
Moisture Content-- BS 1088 plywood must have a moisture content between 6% and 14% when it leaves the factory. Finishing-- Boards will be sanded on both sides equally. Length & Width-- The length or width of a board produced as a standard size shall not be less than the specified size nor more than 6.3 mm (0.25") greater than the specified size.
Veneers are cut as thin as 0.64 mm (1 ⁄ 40 in). Depending on the cutting process used by the veneer manufacturer, very little wood is wasted by the saw blade thickness, known as the saw kerf. Some manufacturers use a very wide knife to slice off the thin veneer pieces. In this process, none of the wood is wasted.
They are normally made of 1 ⁄ 4-inch (6.4 mm) plywood, and are triangles with corners of 45°, 45°, and 90°. They are most often made by ripping the plywood at 6 + 1 ⁄ 2 inches (170 mm) and then mitering it at 45 degree angles to create triangles with 9-inch (230 mm) legs. Keystones join the toggles to the stiles of soft-cover flats.
Re-sawing is the splitting of 1-to-12-inch (25–305 mm) hardwood or softwood lumber into two or more thinner pieces of full-length boards. For example, splitting a 10-foot-long (3.0 m) 2×4 (1 + 1 ⁄ 2 by 3 + 1 ⁄ 2 in or 38 by 89 mm) into two 1×4s (3 ⁄ 4 by 3 + 1 ⁄ 2 in or 19 by 89 mm) of the same length is considered re-sawing.
In 1971 "Micro=Lam LVL" was introduced. "Micro=Lam LVL" consisted of laminated veneer lumber billets 4 feet (1.2 m) wide, 3 + 1 ⁄ 2 inches (89 mm) thick, and 80 feet (24 m) long. Troutner proved the structural capabilities of his Micro=Lam product by building a house in Hagerman, Idaho, using beams made of Micro=Lam.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...
Ad
related to: plywood sizes in mm measurements sheet