Search results
Results from the WOW.Com Content Network
CIM models the network itself using the 'wires model'. It describes the basic components used to transport electricity. Measurements of power are modeled by another class. These measurements support the management of power flow at the transmission level, and by extension, the modeling of power through a revenue meter on the distribution network.
Brake horsepower (bhp) is the power measured using a brake type (load) dynamometer at a specified location, such as the crankshaft, output shaft of the transmission, rear axle or rear wheels. [ 30 ] In Europe, the DIN 70020 standard tests the engine fitted with all ancillaries and the exhaust system as used in the car.
Brake horsepower per cubic centimeter or (bhp/cc) is a figure of merit that is used to indicate the 'state of tune' of an internal combustion engine. It is defined as the ratio of the engine's net power output to its displacement, the internal size. Power is measured at its rated speed and full throttle.
Engine power is the power that an engine can put out. It can be expressed in power units, most commonly kilowatt, pferdestärke (metric horsepower), or horsepower.In terms of internal combustion engines, the engine power usually describes the rated power, which is a power output that the engine can maintain over a long period of time according to a certain testing method, for example ISO 1585.
MSP kWh is the amount of electricity consumed at the 'meter supply point', which is the customer's meter. GSP kWh is obtained by multiplying the MSP kWh by the Line Loss Factor (LLF, a figure > 1) to include the amount of electricity lost when it is conducted through the distribution network, from the 'grid supply point' to the customer's meter.
Where two voltages are given below separated by "/", the first is the root-mean-square voltage between a phase and the neutral connector, whereas the second is the corresponding root-mean-square voltage between two phases (exception: the category shown below called "One Phase", where 240 V is the root-mean-square voltage between the two legs of a split phase).
A field level (or root-power level) is a logarithmic quantity used to measure quantities of which the square is typically proportional to power (for instance, the square of voltage is proportional to power by the inverse of the conductor's resistance), etc., with commonly used units neper (Np) or decibel (dB).
In the power systems analysis field of electrical engineering, a per-unit system is the expression of system quantities as fractions of a defined base unit quantity. . Calculations are simplified because quantities expressed as per-unit do not change when they are referred from one side of a transformer to t