Search results
Results from the WOW.Com Content Network
A pressure switch will energize the pump if hydraulic pressure falls below a preset level and de-energize the pump when pressure returns to normal. A duty cycle of 3 minutes on and a cooling period of 20 minutes off is required to avoid overheating the pump motor.
Overheating of Li-ion cells and battery packs is an ongoing technological challenge for electrochemical energy conversion and storage, including in electric vehicles. Immersion cooling is a promising thermal management technique to address these challenges. [ 26 ]
Dry running protection, also known as dry-run protection or dry-running protection, is a type of protection mechanism to prevent a rotor, pump or stirrer shaft from operating without any medium added, as the bearing and shaft seal might be damaged if the motor is run while dry. [1]
Unlike a thermal fuse, a thermal switch is usually reusable and is therefore suited to protecting against temporary situations which are common and user-correctable. Thermal switches are used in power supplies in case of overload, and also as thermostats, and overheat protection in some heating and cooling systems. They are found in virtually ...
A 0.75 HP bore-well submersible pump which had been used to pump groundwater One style of submersible pump for industrial use. Outlet pipe and electrical cable not connected. A submersible pump (or electric submersible pump (ESP) is a device which has a hermetically sealed motor close-coupled to the pump body. The whole assembly is submerged in ...
When overheating, the temperature of the part rises above the operating temperature. Overheating can take place: if heat is produced in more than expected amount (such as in cases of short-circuits, or applying more voltage than rated), or; if heat dissipation is poor, so that normally produced waste heat does not drain away properly.
Submersible pumps are mounted on two vertical guide rails and seal onto a permanently fixed "duckfoot", which forms both a mount and also a vertical bend for the discharge pipe. For maintenance or replacement, submersible pumps are raised by a chain off of the duckfoot and up the two guide rails to the maintenance (normally ground) level.
A drawback to the bellows thermostat was that it was also sensitive to pressure changes, thus could sometimes be forced shut again by pressure, leading to overheating. [6] The later wax pellet type has a negligible change in its external volume, thus is insensitive to pressure changes. [6] It is otherwise identical in operation to the earlier type.