Search results
Results from the WOW.Com Content Network
Carbon dioxide is used in many consumer products that require pressurized gas because it is inexpensive and nonflammable, and because it undergoes a phase transition from gas to liquid at room temperature at an attainable pressure of approximately 60 bar (870 psi; 59 atm), allowing far more carbon dioxide to fit in a given container than ...
2) is a fluid state of carbon dioxide where it is held at or above its critical temperature and critical pressure. Carbon dioxide usually behaves as a gas in air at standard temperature and pressure (STP), or as a solid called dry ice when cooled and/or pressurised sufficiently. If the temperature and pressure are both increased from STP to be ...
Liquid carbon dioxide is a type of liquid which is formed from highly compressed and cooled gaseous carbon dioxide. It does not form under atmospheric conditions. It only exists when the pressure is above 5.1 atm and the temperature is under 31.1 °C (88.0 °F) (temperature of critical point ) and above −56.6 °C (−69.9 °F) (temperature of ...
Table data obtained from CRC Handbook of Chemistry and Physics 44th ed. Annotation "(s)" indicates equilibrium temperature of vapor over solid. Otherwise temperature is equilibrium of vapor over liquid. For kPa values, where datum is whole numbers of atmospheres exact kPa values are given, elsewhere 2 significant figures derived from mm Hg data.
In the case of pure carbon or carbon monoxide, the two heating values are almost identical, the difference being the sensible heat content of carbon dioxide between 150 °C and 25 °C (sensible heat exchange causes a change of temperature, while latent heat is added or subtracted for phase transitions at constant temperature.
Efficient supercritical CO 2 power cycles requires that the compressor inlet temperature is close to, or even lower than, the critical temperature of the fluid (31 °C for pure carbon dioxide). When this target is reached, and the heat source is higher than 600–650 °C, then the sCO 2 cycle outperforms any Rankine cycle running on water ...
It is manufactured by treating an aqueous solution of potassium carbonate or potassium hydroxide with carbon dioxide: [1] K 2 CO 3 + CO 2 + H 2 O → 2 KHCO 3. Decomposition of the bicarbonate occurs between 100 and 120 °C (212 and 248 °F): 2 KHCO 3 → K 2 CO 3 + CO 2 + H 2 O. This reaction is employed to prepare high purity potassium carbonate.
Most of the carbonic acid then dissociates to bicarbonate and hydrogen ions. The bicarbonate buffer system is an acid-base homeostatic mechanism involving the balance of carbonic acid (H 2 CO 3), bicarbonate ion (HCO − 3), and carbon dioxide (CO 2) in order to maintain pH in the blood and duodenum, among other tissues, to support proper ...