Search results
Results from the WOW.Com Content Network
AlSiC, pronounced "alsick", [1] is a metal matrix composite consisting of aluminium matrix with silicon carbide particles. It has high thermal conductivity (180–200 W/m K), and its thermal expansion can be adjusted to match other materials, e.g. silicon and gallium arsenide chips and various ceramics.
Aluminium oxide or Alumina and Silicon carbide are most commonly used to prepare titanium for epoxy bonding. Alumina has a hardness of 9 on the Mohs scale while silicon carbide has a hardness of just under that of diamond. [5] Alumina particle sizes in the 10 to 150 micron range are used depending on the workpiece geometry and blasting ...
In lighting, translucent aluminium oxide is used in some sodium vapor lamps. [47] Aluminium oxide is also used in preparation of coating suspensions in compact fluorescent lamps. In chemistry laboratories, aluminium oxide is a medium for chromatography, available in basic (pH 9.5), acidic (pH 4.5 when in water) and neutral formulations.
Air abrasion is a dental technique that uses compressed air to propel a thin stream of abrasive particles—often aluminum oxide or silica—through a specialized hand-piece to remove tooth tissue and decay before being suctioned away, similar to sand blasting.
Silicon carbide (SiC), also known as carborundum (/ ˌ k ɑːr b ə ˈ r ʌ n d əm /), is a hard chemical compound containing silicon and carbon. A wide bandgap semiconductor , it occurs in nature as the extremely rare mineral moissanite , but has been mass-produced as a powder and crystal since 1893 for use as an abrasive .
This tendency can be decreased by coating the silicon carbide particles with a suitable oxide or nitride, preoxidation of the particles to form a silica coating, or using a layer of sacrificial metal. [9] An aluminium-aluminium carbide composite material can be made by mechanical alloying, by mixing aluminium powder with graphite particles.
Aluminium-silicon alloys typically contain 3% to 25% silicon content. [1] Casting is the primary use of aluminum-silicon alloys, but they can also be utilized in rapid solidification processes and powder metallurgy. Alloys used by powder metallurgy, rather than casting, may contain even more silicon, up to 50%. [1]
This mixture of binder and abrasive is typically shaped into blocks, sticks, or wheels. The most common abrasive used is aluminium oxide. Also common are silicon carbide, tungsten carbide and garnet. Artificial sharpening stones are often a bonded abrasive and are readily available as a two sided block, each side being a different grade of grit.