Search results
Results from the WOW.Com Content Network
Harbor Freight Tools won a declassification of the class action; that is, the court found that all the individual situations were not similar enough to be judged as a single class, and that their claims would require an individual-by-individual inquiry, so the case could not be handled on a class basis.
The most common fence on a table saw is a rip fence, and is provided as standard with any new table saw. The rip fence is parallel to the saw blade and can be adjusted to different distances from the blade to set the size of the final cut. The fence remains static, while the workpiece is guided along the fence. [5]
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, Alemite fitting, or divit is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
The term abrasive jet refers specifically to the use of a mixture of water and an abrasive to cut hard materials such as metal, stone or glass, while the terms pure waterjet and water-only cutting refer to waterjet cutting without the use of added abrasives, often used for softer materials such as wood or rubber.
A vinyl cutter. A vinyl cutter is an entry-level machine for making signs. Computer-designed vector files with patterns and letters are directly cut on the roll of vinyl which is mounted and fed into the vinyl cutter through USB or serial cable. Vinyl cutters are mainly used to make signs, banners and advertisements.
Besides cooling, cutting fluids also aid the cutting process by lubricating the interface between the tool's cutting edge and the chip. By preventing friction at this interface, some of the heat generation is prevented. This lubrication also helps prevent the chips from being welded onto the tool, which would interfere with subsequent cutting.
There are many different kinds of honing oils to suit different needs. It is important to use the appropriate solution for the job. In the case of knife sharpening, motor oil is too thick or heavy and can over-lubricate or clog a sharpening stone, whereas WD-40 is too light an oil and will not carry the metal filings plus stone dust (collectively known as swarf) away from the stone, and clog it.
A high velocity cutting flame is produced by the huge volume expansion while the liquid transitions to a vapour so the cutting flame can cut across voids (air space between plates). Oxy-gasoline torches can also cut through paint, dirt, rust and other contaminating surface materials coating old steel.