Search results
Results from the WOW.Com Content Network
The naming convention for DDR, DDR2 and DDR3 modules specifies either a maximum speed (e.g., DDR2-800) or a maximum bandwidth (e.g., PC2-6400). The speed rating (800) is not the maximum clock speed, but twice that (because of the doubled data rate). The specified bandwidth (6400) is the maximum megabytes transferred per second using a 64-bit width.
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
Floating point operations per second (FLOPS, flops or flop/s) is a measure of computer performance in computing, useful in fields of scientific computations that require floating-point calculations. [1] For such cases, it is a more accurate measure than measuring instructions per second. [citation needed]
While the gross data rate equals 33.3 million 4-bit-transfers per second (or 16.67 MB/s), the fastest transfer, firmware read, results in 15.63 MB/s. The next fastest bus cycle, 32-bit ISA-style DMA write, yields only 6.67 MB/s .
So a designation of 9600-8-E-2 would be 9,600 bits per second, with eight bits per character, even parity and two stop bits. A common set-up of an asynchronous serial connection would be 9600-8-N-1 (9,600 bit/s, 8 bits per character, no parity and 1 stop bit) - a total of 10 bits transmitted to send one 8 bit character (one start bit, the 8 ...
Writing a DVD at 1× (1 385 000 bytes per second) [5] is approximately 9 times faster than writing a CD at 1× (153 600 bytes per second). [6] However, the actual speeds depend on the type of data being written to the disc. [6] For Blu-ray discs, 1× speed is defined as 36 megabits per second (Mbit/s), which is equal to 4.5 megabytes per second ...
The module works at 2133 MHz, with a 64-bit I/O, and processes up to 17 GB of data per second. 2016: In April, Samsung announced that they had begun to mass-produce DRAM on a "10 nm-class" process, by which they mean the 1x nm node regime of 16 nm to 19 nm, which supports a 30% faster data transfer rate of 3,200 Mbit/s. [ 38 ]