Search results
Results from the WOW.Com Content Network
Powerline worker performs maintenance of a lightning arrester on an electrical transmission tower in New Brunswick, Canada. A lightning arrester (alternative spelling lightning arrestor) (also called lightning isolator) is a device, essentially an air gap between an electric wire and ground, used on electric power transmission and telecommunication systems to protect the insulation and ...
A lightning rod or lightning conductor (British English) is a metal rod mounted on a structure and intended to protect the structure from a lightning strike. If lightning hits the structure, it is most likely to strike the rod and be conducted to ground through a wire, rather than passing through the structure, where it could start a fire or ...
A lightning rod at the highest point of a tall building, connected to a ground rod by a wire. Español: Diagrama de un sistema de pararrayos simple. Un pararrayos en el punto más alto de un edificio alto, conectado a una varilla de tierra por un cable.
Surge Protection Device (SPD) for installation in a low-voltage distribution board. A surge protector (or spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD), transient voltage suppressor (TVS) or transient voltage surge suppressor (TVSS)) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes ...
However, a direct lightning strike (such as on a radio tower antenna) will cause the shunt to arc and conduct the massive amount of electricity to ground, protecting transmitters and other equipment. Another older form of lightning arrester employs a simple narrow spark gap, over which an arc will jump when a high voltage is present.
[2] [5] The "8/20 μs" generator is designed for surge arrester testing, and produces a high-current surge into a low-impedance load. [2] On the other hand, modern electronic devices can be high and low-impedance loads simultaneously due to non-linear devices, protection circuits, and arcing in a dielectric breakdown.
Connectors for earthing installation are a means of communication between the various components of the earthing and lightning protection installations (earthing rods, earthing conductors, current leads, busbars, etc.). For high voltage installations, exothermic welding is used for underground connections.
IEC TR 61831 On-line analyser systems – Guide to design and installation IEC TR 61832 Design and installation of on-line analyser systems – Guide to technical enquiry and bid evaluation IEC 61834 Recording – Helical-scan digital video cassette recording system using 6,35 mm magnetic tape for consumer use (525-60, 625–50, 1125–60 and ...