Search results
Results from the WOW.Com Content Network
NodeMCU DEVKIT 1.0, bottom. NodeMCU is a low-cost open source IoT platform. [4] [5] It initially included firmware which runs on the ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which was based on the ESP-12 module. [6] [7] Later, support for the ESP32 32-bit MCU was added.
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
Arduino (/ ɑː r ˈ d w iː n oʊ /) is an Italian open-source hardware and software company, project, and user community that designs and manufactures single-board microcontrollers and microcontroller kits for building digital devices.
Though 3rd-party boards have similar board names it doesn't automatically mean they are 100% identical to official Arduino boards. 3rd-party boards often have a different voltage regulator / different USB-to-UART chip / different color solder mask , and some have a different USB connector or additional features, too.
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
The board can be supplied with power either from the DC power jack (7 - 20V), the USB connector (5V), or the VIN pin of the board (7-20V). Supplying voltage via the 5V or 3.3V pins bypasses the regulator, and can damage the board. 3V3: A 3.3 volt supply generated by the on-board regulator. Maximum current draw is 50 mA.