Search results
Results from the WOW.Com Content Network
A theodolite is used to measure the horizontal angle between indicators on the two ends of the subtense bar. The distance from the telescope to the subtense bar is the height of an isosceles triangle formed with the theodolite at the upper vertex and the subtense bar length at its base, determined by trigonometry.
Transistor tester: Tests transistors Tube tester: Tests vacuum tubes (triode, tetrode etc.) Wattmeter: Measures power in a circuit Vectorscope: Displays the phase of the colors in color TV Video signal generator: Generates video signal for testing purposes Voltmeter: Measures the potential difference between two points in a circuit. (Includes ...
Thermistors principle: relation between temperature and electrical resistance of ceramics or polymers, range: from about 0.01 to 2,000 kelvins (−273.14 to 1,700 °C) Thermocouples principle: relation between temperature and voltage of metal junctions ( Seebeck effect ), range: from about −200 °C to +1350 °C
A total station or total station theodolite is an electronic/optical instrument used for surveying and building construction. It is an electronic transit theodolite integrated with electronic distance measurement (EDM) to measure both vertical and horizontal angles and the slope distance from the instrument to a particular point, and an on ...
The difference between the revenue from selling a unit of electricity and the cost of the fuel used to make it. spark-gap transmitter A former type of radio transmitter that generated radio frequency current by exciting resonance of a tuned system with an electric spark, used almost entirely for transmission of Morse code. spectrum analyzer
A tachometer (revolution-counter, tach, rev-counter, RPM gauge) is an instrument measuring the rotation speed of a shaft or disk, as in a motor or other machine. [1] The device usually displays the revolutions per minute (RPM) on a calibrated analogue dial, but digital displays are increasingly common.
More advanced current probes combine a Hall effect sensor with a current transformer. The Hall effect sensor measures the DC and low frequency components of the signal and the current transformer measures the high frequency components. These signals are combined in the amplifier circuit to yield a wide band signal extending from DC to over 50 MHz.
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.