enow.com Web Search

  1. Ads

    related to: adhesive for plastic waste pipe sizes and weight

Search results

  1. Results from the WOW.Com Content Network
  2. Weld-On - Wikipedia

    en.wikipedia.org/wiki/Weld-On

    Weld-On is a division of IPS Corporation, a manufacturer of solvent cements, primers, and cleaners for PVC, CPVC, and ABS plastic piping systems. Weld-On products are commonly used for joining plastic pipes and fittings. Weld-On also manufactures specialty products from repair adhesives for leaking pipes, pipe thread sealants / joint compounds ...

  3. Plastic pipework - Wikipedia

    en.wikipedia.org/wiki/Plastic_pipework

    Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.

  4. List of adhesive tapes - Wikipedia

    en.wikipedia.org/wiki/List_of_adhesive_tapes

    Adhesive is usually coated on a polypropylene or polyester film. Commonly 48 mm (1.9 in) or 72 mm (2.8 in) wide. Double-sided tape This tape has adhesive on both sides, and is used to stick two surfaces together. Duct tape Usually gray in color, this tape is backed with scrim, often coated with rubber or plastic. [1] Elastic therapeutic tape

  5. Thread seal tape - Wikipedia

    en.wikipedia.org/wiki/Thread_seal_tape

    PTFE tape used for different sized fittings PTFE tape for natural gas. There are two US standards for determining the quality of any thread seal tape. MIL-T-27730A (an obsolete military specification still commonly used in industry in the US) requires a minimum thickness of 3.5 mils and a minimum PTFE purity of 99%. [3]

  6. Polybutylene - Wikipedia

    en.wikipedia.org/wiki/Polybutylene

    PB-1 is a high molecular weight, linear, isotactic, and semi-crystalline polymer. PB-1 combines typical characteristics of conventional polyolefins with certain properties of technical polymers. PB-1, when applied as a pure or reinforced resin , can replace materials like metal, rubber and engineering polymers.

  7. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    [18]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings. These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life.

  8. Poly(p-phenylene oxide) - Wikipedia

    en.wikipedia.org/wiki/Poly(p-phenylene_oxide)

    This plastic is processed by injection molding or extrusion; depending on the type, the processing temperature is 260–300 °C. The surface can be printed, hot-stamped, painted or metallized. Welds are possible by means of heating element, friction or ultrasonic welding. It can be glued with halogenated solvents or various adhesives.

  9. Chemistry of pressure-sensitive adhesives - Wikipedia

    en.wikipedia.org/wiki/Chemistry_of_pressure...

    A typical PSA tape consists of a pressure-sensitive adhesive (the sticky part of the tape) coated to a backing material. To prevent the adhesive from sticking to the backing when wound in a roll, a release agent is applied to the backing or a release liner is placed on the adhesive. Sometimes a primer is coated between the adhesive and backing ...

  1. Ads

    related to: adhesive for plastic waste pipe sizes and weight