Search results
Results from the WOW.Com Content Network
It is 5.5 typographical points, or about 1 ⁄ 13 inch (1.94 mm). It can refer either to the height of a line of type or to a font that is 5.5 points. An agate font is commonly used to display statistical data or legal notices in newspapers. It is considered to be the smallest point size that can be printed on newsprint and remain legible ...
Successive paper sizes in the series (A1, A2, A3, etc.) are defined by halving the area of the preceding paper size and rounding down, so that the long side of A(n + 1) is the same length as the short side of An. Hence, each next size is nearly exactly half the area of the prior size. So, an A1 page can fit two A2 pages inside the same area.
Wide ruled (or legal ruled) paper has 11 ⁄ 32 in (8.7 mm) spacing between horizontal lines, with a vertical margin drawn about 1 + 1 ⁄ 4 inches (32 mm) from the left-hand edge of the page. It is commonly used by American children in grade school, as well as by those with larger handwriting.
The American pica of 0.16604 inches (4.217 mm). It was established by the United States Type Founders' Association in 1886. [1] [2] In TeX one pica is 400 ⁄ 2,409 of an inch. The contemporary computer PostScript pica is exactly 1 ⁄ 6 of an inch or 1 ⁄ 72 of a foot, i.e. 4.2 3 mm or 0.1 6 in.
A ruler with two linear scales: the metric and imperial.It includes shorter minor graduations and longer major graduations. A graduation is a marking used to indicate points on a visual scale, which can be present on a container, a measuring device, or the axes of a line plot, usually one of many along a line or curve, each in the form of short line segments perpendicular to the line or curve.
It has the height of Canadian P4 paper (215 mm × 280 mm, about 8 + 1 ⁄ 2 in × 11 in) and the width of international A4 paper (210 mm × 297 mm or 8.27 in × 11.69 in), i.e. it uses the smaller value among the two for each side. The table shows how this format can be generalized into an entire format series.
The size and proportions of a book depend on the size of the original full sheet. If a sheet 480 by 640 mm (19 by 25 in) is used to print a quarto, the resulting untrimmed pages, will be approximately half as large in each dimension: width 240 mm (9 + 1 ⁄ 2 in) and height 320 mm (12 + 1 ⁄ 2 in).
The French National Print Office adopted a point of 2 ⁄ 5 mm or 0.400 mm in about 1810 and continues to use this measurement today (though "recalibrated" to 0.398 77 mm). [ 21 ] [ 22 ] [ 23 ] Japanese [ 24 ] and German [ 9 ] [ 16 ] [ 18 ] standardization bodies instead opted for a metric typographic base measure of exactly 1 ⁄ 4 mm or 0.250 ...