enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Dana 30 - Wikipedia

   en.wikipedia.org/wiki/Dana_30

   The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions. 2011 Jeep Dana 30 differential Jeep Dana 30

3. GM 10.5-inch 14-bolt differential - Wikipedia

   en.wikipedia.org/wiki/GM_10.5-inch_14-bolt...

   The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.

4. Jeep Cherokee (XJ) - Wikipedia

   en.wikipedia.org/wiki/Jeep_Cherokee_(XJ)

   1996–1999: Dana 30, high pinion, reverse cut, 297x/760 universal joint, 27-spline axle shafts 2000–2001: Dana 30, low pinion, standard cut, 297x/760 universal joint, 27-spline axle shafts 1985–2001: straight non-driven front axle for two-wheel drive only

5. Jeep CJ - Wikipedia

   en.wikipedia.org/wiki/Jeep_CJ

   The Dana 30 front axle was retained, but the locking hubs were changed to a five-bolt retaining pattern versus the older six-bolt. The demise of the AMC CJ5 model has been attributed to a December 1980 60 Minutes segment where the Insurance Institute for Highway Safety (IIHS) staged a demonstration to illustrate that the CJ5 was apt to roll ...

6. Front axle assembly - Wikipedia

   en.wikipedia.org/wiki/Front_axle_assembly

   The front axle assembly of a wagon consists of an axle, a pair of wheels and a round plate with a kingpin in its centre that sits halfway between the wheels, which may be mounted on spindles. [2] A round plate with a hole in its centre is located on the underside of the wagon. The plate on the wagon, in turn, sits on the plate on the axle ...

7. International Scout - Wikipedia

   en.wikipedia.org/wiki/International_Scout

   The front axle was still a Dana 27, though a 3,500 lb (1,600 kg) axle upgrade option used a hybrid unit built from a Dana 30 center section and 27 tubes. The V8 engine option included an upgrade to the heavier-duty Dana 30 axle. The rear axle shafts changed from two pieces to one piece around 1968 or 1969.