Search results
Results from the WOW.Com Content Network
Some premium speaker cables have lower inductance at the cost of higher capacitance; 0.02-0.05μH/ft is typical, which at the worst end means that a run of up to about 40 feet will have less than 1% inductive loss (40 ft * 0.05 μH/ft = 2.0& μH).
There is an active hobbyist speaker construction group on the Web focusing on full-range drivers and enclosures for them. Since every electronic, mechanical or acoustical component in reproduction chain will, regardless of purpose, degrade fine detail, the fewer components between the amplifier terminals and the listening room, the better.
All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.
Headphone outputs and line outputs are sometimes confused. Different make and model headphones have widely varying impedances, from as little as 20 Ω to a few hundred ohms; the lowest of these will have results similar to a speaker, while the highest may work acceptably if the line out impedance is low enough and the headphones are sensitive ...
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]
A near-field speaker is a compact studio monitor designed for listening at close distances (3 to 5 feet (0.9 to 1.5 m)), so, in theory, the effects of poor room acoustics are greatly reduced.) The 4310 was small enough to be placed on the recording console and listened to from much closer distances than the traditional large wall-(or "soffit ...
Acoustic Research was a Cambridge, Massachusetts-based company that manufactured high-end audio equipment. The brand is now owned by VOXX.Acoustic Research was known for the AR-3 series of speaker systems, which used the 12 in (300 mm) acoustic suspension woofer of the AR-1 with newly designed dome mid-range speaker and high-frequency drivers.
However, whereas a 5.1 surround sound system combines both surround and rear channel effects into two channels (commonly configured in home theatre set-ups as two rear surround speakers), a 7.1 surround system splits the surround and rear channel information into four distinct channels, in which sound effects are directed to left and right ...