enow.com Web Search

  1. Ads

    related to: 2 hp sump pumps submersible at lowe s 40 gal nat gas water heater

Search results

  1. Results from the WOW.Com Content Network
  2. Sump pump - Wikipedia

    en.wikipedia.org/wiki/Sump_pump

    Since the level control switch is the primary point of failure with any sump pump, submersible pumps with auxiliary, or "piggyback", designs allow for replacement of the switch with minimal effort. Today, submersible pumps are the most popular style, while residential pedestal pumps are low volume, economical designs with limited service life. [3]

  3. Sewage pumping - Wikipedia

    en.wikipedia.org/wiki/Sewage_pumping

    Three classes of submersible pumps exist: Smaller submersible pumps, used in domestic and light commercial applications, normally handle up to 55 millimetres (2.2 in) spherical solids and range from 0.75 to 2.2 kilowatts (1.01 to 2.95 hp). Larger submersible pumps, handle 65 millimetres (2.6 in) and larger solids and normally have a minimum of ...

  4. Storage water heater - Wikipedia

    en.wikipedia.org/wiki/Storage_water_heater

    Solar heat is clean and renewable. This is the most modern system. Increasingly, solar powered water heaters are being used. Their solar thermal collectors are installed outside dwellings, typically on the roof or walls or nearby, and the potable hot water storage tank is typically a pre-existing or new conventional water heater, or a water heater specifically designed for solar thermal.

  5. Grinder pump - Wikipedia

    en.wikipedia.org/wiki/Grinder_pump

    A pump for household use is usually 1 hp, 1.5 hp or 2 hp. A cutting mechanism macerates waste and grinds items that are not normally found in sewage, but may get flushed down the toilet. The pump has a level sensor either built into the pump, called “sensing bells,” or attached externally to the pump, typically a float switch. (The level ...

  6. Pumping station - Wikipedia

    en.wikipedia.org/wiki/Pumping_station

    Submersible pumps are mounted on two vertical guide rails and seal onto a permanently fixed "duckfoot", which forms both a mount and also a vertical bend for the discharge pipe. For maintenance or replacement, submersible pumps are raised by a chain off of the duckfoot and up the two guide rails to the maintenance (normally ground) level.

  7. Water heating - Wikipedia

    en.wikipedia.org/wiki/Water_heating

    In the United States, typical natural gas water heaters for households without unusual needs are 150–190 L (40–50 US gal) with a burner rated at 10.0–11.7 kilowatts (34,000–40,000 BTU/h). This is a popular arrangement where higher flow rates are required for limited periods.

  1. Ads

    related to: 2 hp sump pumps submersible at lowe s 40 gal nat gas water heater