Search results
Results from the WOW.Com Content Network
The principal packet structure of ARP packets is shown in the following table which illustrates the case of IPv4 networks running on Ethernet. In this scenario, the packet has 48-bit fields for the sender hardware address (SHA) and target hardware address (THA), and 32-bit fields for the corresponding sender and target protocol addresses (SPA ...
Secure Packet Shield: 0x83 131 PIPE Private IP Encapsulation within IP Expired I-D draft-petri-mobileip-pipe-00.txt: 0x84 132 SCTP Stream Control Transmission Protocol: RFC 4960: 0x85 133 FC Fibre Channel: 0x86 134 RSVP-E2E-IGNORE Reservation Protocol (RSVP) End-to-End Ignore RFC 3175: 0x87 135 Mobility Header Mobility Extension Header for IPv6 ...
Reverse ARP differs from the Inverse Address Resolution Protocol (InARP), which is designed to obtain the IP address associated with a local Frame Relay data link connection identifier. [2] InARP is not used in Ethernet .
Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport mechanisms.
This article lists protocols, categorized by the nearest layer in the Open Systems Interconnection model.This list is not exclusive to only the OSI protocol family.Many of these protocols are originally based on the Internet Protocol Suite (TCP/IP) and other models and they often do not fit neatly into OSI layers.
EtherType is also used as the basis of 802.1Q VLAN tagging, encapsulating packets from VLANs for transmission multiplexed with other VLAN traffic over an Ethernet trunk. EtherType was first defined by the Ethernet II framing standard and later adapted for the IEEE 802.3 standard. EtherType values are assigned by the IEEE Registration Authority.
The internet layer is a group of internetworking methods, protocols, and specifications in the Internet protocol suite that are used to transport network packets from the originating host across network boundaries; if necessary, to the destination host specified by an IP address.
In the seven-layer OSI model of computer networking, packet strictly refers to a protocol data unit at layer 3, the network layer. [2] A data unit at layer 2, the data link layer , is a frame . In layer 4, the transport layer , the data units are segments and datagrams .