enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

3. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   All three patterns may also be combined with a slot for a flat-blade screwdriver. Usually they are provided with a 1/4 in (0.25 inches (6.4 mm)) flanged hex head. Non-standard metricized 5.5 millimetres (0.22 in) flanged hex heads can also be encountered. Also common are pan head screws - a low disk with a chamfered outer edge.

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   A hex screw drive uses six-sided fastener heads, and the fastener is known as a hex head cap screw. It can be turned with an adjustable wrench, combination wrench and 6- or 12-point sockets. The hex drive is better than square drive for locations where surrounding obstacles limit wrenching access, because smaller wrench-swing arcs can still ...

5. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   4.1 List of hex head sizes. 5 Comparison with other standards. 6 Current usage. ... The Whitworth thread was the world's first national screw thread standard, [1] ...

6. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   Cap head screws of various sizes Button head screws. Hex keys are best known as "Allen keys" or "Allen wrenches" in English-speaking countries like the UK, Australia, Canada and the U.S. and in Spanish-speaking countries such as Spain and Mexico (The "Allen" name is a registered trademark, originated by the Allen Manufacturing Company of ...

7. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A typical lag screw can range in diameter from 4 to 20 mm or #10 to 1.25 in (4.83 to 31.75 mm), and lengths from 16 to 200 mm or 1 ⁄ 4 to 6 in (6.35 to 152.40 mm) or longer, with the coarse threads of a wood-screw or sheet-metal-screw threadform (but larger).