Search results
Results from the WOW.Com Content Network
[1] [2] The word hydrophobic literally means "water-fearing", and it describes the segregation of water and nonpolar substances, which maximizes the entropy of water and minimizes the area of contact between water and nonpolar molecules. In terms of thermodynamics, the hydrophobic effect is the free energy change of water surrounding a solute. [3]
Lipophilicity (from Greek λίπος "fat" and φίλος "friendly") is the ability of a chemical compound to dissolve in fats, oils, lipids, and non-polar solvents such as hexane or toluene. Such compounds are called lipophilic (translated as "fat-loving" or "fat-liking" [ 1 ] [ 2 ] ).
Except she filled the tub with too much oil and ended up getting stranded in the tub after she drained the water. She posted her dilemma to the internet, soliciting advice and help from Imgur. I ...
Another example is soap, which has a hydrophilic head and a hydrophobic tail, allowing it to dissolve in both water and oil. Hydrophilic and hydrophobic molecules are also known as polar molecules and nonpolar molecules, respectively. Some hydrophilic substances do not dissolve. This type of mixture is called a colloid.
The most efficient method of industrial oil degassing is vacuum processing, which removes air and water solved in the oil. [6] This can be achieved by: spraying of oil in large vacuum chambers; distributing the oil into a thin layer over special surfaces (spiral rings, Raschig rings etc) in vacuum chambers.
Diesel fuel is immiscible in water.The bright rainbow pattern is the result of thin-film interference.. Miscibility (/ ˌ m ɪ s ɪ ˈ b ɪ l ɪ t i /) is the property of two substances to mix in all proportions (that is, to fully dissolve in each other at any concentration), forming a homogeneous mixture (a solution).
“This is why women continue to have normal periods for up to a decade after they can no longer get pregnant with their own eggs.” But Dr. Williams stresses that this is about more than fertility.
Overheating the oil bath can result in a fire hazard, especially if mineral oil is being used. Generally, the maximum safe operating temperature of a mineral oil bath is approximately 160 °C (320 °F), the oil's flash point. Mineral oil cannot be used above 310 °C (590 °F) due to the compound's boiling point.