Search results
Results from the WOW.Com Content Network
In the paint and coating industries, paint adhesion testing is often used to determine if the paint or coating will adhere properly to the substrates to which they are applied. Several tests measure the resistance of paints and coatings from substrates: cross-cut test, scrape adhesion, pull-off test , and others.
Toxicity characteristic leaching procedure (TCLP) is a soil sample extraction method for chemical analysis employed as an analytical method to simulate leaching through a landfill. The testing methodology is used to determine if a waste is characteristically hazardous, i.e., classified as one of the "D" listed wastes by the U.S. Environmental ...
A test patch should be as clean as possible. Contamination of a patch can influence the results significantly. Bresle patch injected with 15ml water as in ISO 8502-6 Annex A. The ISO 8502-6 standard prescribes in annex A that certified patches shall be used. This annex describes a stress test to ensure patch adhesion and wash ability.
A pull-off test, also called stud pull test, is a type of test in which an adhesive connection is made between a stud and a carrier (or object to be tested) by using a glue, possibly an epoxy or polyester resin, that is stronger than the bond that needs to be tested.
Determining the fineness of a paint's grind is important, because too coarse a grind may reduce the paint's color uniformity, gloss, and opacity. [7] The Hegman gauge is widely used for this purpose because it requires minimal skill and only a few seconds' work.
In geotechnical engineering, a soil test can be used to determine the physical characteristics of a soil, such as its water content, void ratio or bulk density. Soil testing can also provide information related to the shear strength, rate of consolidation and permeability of the soil. The following is a non-exhaustive list of engineering soil ...
The cone penetration or cone penetrometer test (CPT) is a method used to determine the geotechnical engineering properties of soils and delineating soil stratigraphy. It was initially developed in the 1950s at the Dutch Laboratory for Soil Mechanics in Delft to investigate soft soils.
Paint and other coatings that are on slanted or vertical surfaces tend to sag when first applied. The thickness of the coating as well as the composition and viscosity will affect the overall sagging and conversely the sag resistance. In order to find the sag resistance of a coating a simple test is used.