Search results
Results from the WOW.Com Content Network
The available volume for additional water in the soil depends on the porosity of the soil [7] and the rate at which previously infiltrated water can move away from the surface through the soil. The maximum rate at that water can enter soil in a given condition is the infiltration capacity. If the arrival of the water at the soil surface is less ...
In that case, earthwork software is principally used to calculate cut and fill volumes which are then used for producing material and time estimates. Most products offer additional functionality such as the ability to takeoff terrain elevation from plans (using contour lines and spot heights ); produce shaded cut and fill maps; produce cross ...
Infiltration is the process by which water on the ground surface enters the soil. The water enters the soil through the pores by the forces of gravity and capillary action. The largest cracks and pores offer a great reservoir for the initial flush of water. This allows a rapid infiltration. The smaller pores take longer to fill and rely on ...
It is also known as available water content (AWC), profile available water (PAW) [2] or total available water (TAW). The concept, put forward by Frank Veihmeyer and Arthur Hendrickson, [ 3 ] assumed that the water readily available to plants is the difference between the soil water content at field capacity ( θ fc ) and permanent wilting point ...
The soil moisture velocity equation [1] describes the speed that water moves vertically through unsaturated soil under the combined actions of gravity and capillarity, a process known as infiltration. The equation is alternative form of the Richardson/Richards' equation.
the discharge rate (Q) from the recharge rate (R) in a water balance as detailed in the article: hydrology (agriculture) the permissible long term average depth of the water table (Dw) on the basis of agricultural drainage criteria; the soil's hydraulic conductivity (Ka and Kb) by measurements; the depth of the bottom of the aquifer (Di)
The Liquid Limit is the water content at which the soil behavior transitions from a plastic solid to a liquid. The Plastic Limit is the water content at which the soil behavior transitions from that of a plastic solid to a brittle solid. The Shrinkage Limit corresponds to a water content below which the soil will not shrink as it dries.
For a confined aquifer or aquitard, storativity is the vertically integrated specific storage value. Specific storage is the volume of water released from one unit volume of the aquifer under one unit decline in head. This is related to both the compressibility of the aquifer and the compressibility of the water itself.